[U-Boot] Please pull u-boot-ti/master

Igor Grinberg grinberg at compulab.co.il
Sun Jun 9 10:07:58 CEST 2013


Hi Lubomir,

On 06/08/13 23:43, Lubomir Popov wrote:
> Hi Tom, Michael,
> 
>> Hello,
>>
>> The following changes since commit 3da0e5750b24a9491058df6126c7be577a276c09:
>>
>>   arm: factorize relocate_code routine (2013-05-30 20:24:38 +0200)
>>
>> are available in the git repository at:
>>
>>   git://git.denx.de/u-boot-ti.git master
>>
>> for you to fetch changes up to 80dd596d1b442ff53dbeb33eccdb8efd2283be79:
>>
> 
> [snip]
> 
>> Michael Trimarchi (1):
>>       usb: omap: ulpi: fix ulpi transceiver access
> 
> [snip]
> 
>>  drivers/usb/ulpi/omap-ulpi-viewport.c              |   40 +-
> 
> [snip]
> 
> I just made a clean clone of u-boot-ti/master, manually applied the
> changes to the ehci files, added my board files and made a build.
> Everything seems to work fine, but I see an error message regarding
> ULPI reset that was not present before, and obviously it is due to
> Michael's changes:

Yes indeed, those are due to Michael's patch.
Michael's patch aligns the code with the TRM and seems to reveal
an OMAP USB bug might an erratum.

> 
> SOM5_EVB # usb start
> (Re)start USB...
> USB0:   ULPI: ulpi_reset: failed writing reset bit
> USB EHCI 1.00
> scanning bus 0 for devices... 6 USB Device(s) found
>        scanning usb for storage devices... 3 Storage Device(s) found
>        scanning usb for ethernet devices... 1 Ethernet Device(s) found
> SOM5_EVB # usb tree
> USB device tree:
>   1  Hub (480 Mb/s, 0mA)
>   |  u-boot EHCI Host Controller
>   |
>   +-2  Mass Storage (480 Mb/s, 200mA)
>   |    FSC                  MEMORYBIRD USB2      C157040817120315AA
>   |
>   +-3  Hub (480 Mb/s, 2mA)
>   | |
>   | +-4  Mass Storage (480 Mb/s, 96mA)
>   | |    Generic Ultra Fast Media Reader 000000264001
>   | |
>   | +-5  Mass Storage (480 Mb/s, 100mA)
>   |      USB Flash Drive 531C43B21928F11F
>   |
>   +-6  Vendor specific (480 Mb/s, 500mA)
> 
> SOM5_EVB #
> 
> Otherwise everything is OK, the device on the ULPI port is working
> (it is #2 above). It is now late and I shall investigate in detail
> tomorrow, this is just an early warning ;)
> 
> Best regards,
> Lubo
> 
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot
> 

-- 
Regards,
Igor.


More information about the U-Boot mailing list