[U-Boot] [PATCH v2 1/4] udoo: Add ethernet support (FEC + Micrel KSZ9031).

[Fabio Estevam]

Hi Stefano,

On Mon, Nov 18, 2013 at 1:51 PM, Stefano Babic <sbabic at denx.de> wrote:
> Hi Giuseppe,
>
> On 15/11/2013 17:42, Giuseppe Pagano wrote:
>> Add Ethernet and networking support on uDoo board (FEC +phy Micrel KSZ9031).
>> Ethernet speed is currently limited to 10/100Mbps.
>>
>> Signed-off-by: Giuseppe Pagano <giuseppe.pagano at seco.com>
>> Tested-by: Fabio Estevam <fabio.estevam at freescale.com>
>> CC: Stefano Babic <sbabic at denx.de>
>> CC: Fabio Estevam <fabio.estevam at freescale.com>
>> ---
>
> IMHO the patch is ok. If there are not any further comments, I mark your
> patchset for merging.

Please apply this series when you have a chance.

I would like to send some other patches to udoo board that depends on
this series.

Regards,

Fabio Estevam