[U-Boot] [PATCH v2 1/4] udoo: Add ethernet support (FEC + Micrel KSZ9031).

[Stefano Babic]

Hi Giuseppe,

On 15/11/2013 17:42, Giuseppe Pagano wrote:
> Add Ethernet and networking support on uDoo board (FEC +phy Micrel KSZ9031).
> Ethernet speed is currently limited to 10/100Mbps.
> 
> Signed-off-by: Giuseppe Pagano <giuseppe.pagano at seco.com>
> Tested-by: Fabio Estevam <fabio.estevam at freescale.com>
> CC: Stefano Babic <sbabic at denx.de>
> CC: Fabio Estevam <fabio.estevam at freescale.com>
> ---

I slightly change the patch to fix names of pins according to last
patches to consolidate names between i.MX6 flavour.

Applied to u-boot-imx, thanks.

Best regards,
Stefano Babic




-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================