[U-Boot] [PATCH v3 1/1] udoo: Add SATA support on uDoo Board.

[Giuseppe Pagano]

Add SATA support on uDoo Board.

Signed-off-by: Giuseppe Pagano <giuseppe.pagano at seco.com>
CC: Stefano Babic <sbabic at denx.de>
CC: Fabio Estevam <fabio.estevam at freescale.com>
---

Changes in v3:
  - No changes.

Changes in v2:
  - Split previous patch between nitrogen6x udoo code changes.
---
 board/udoo/udoo.c      |    4 ++++
 include/configs/udoo.h |   12 ++++++++++++
 2 files changed, 16 insertions(+)

diff --git a/board/udoo/udoo.c b/board/udoo/udoo.c
index 0c38d9b..5b055f7 100644
--- a/board/udoo/udoo.c
+++ b/board/udoo/udoo.c
@@ -14,6 +14,7 @@
 #include <asm/errno.h>
 #include <asm/gpio.h>
 #include <asm/imx-common/iomux-v3.h>
+#include <asm/imx-common/sata.h>
 #include <mmc.h>
 #include <fsl_esdhc.h>
 #include <asm/arch/crm_regs.h>
@@ -239,6 +240,9 @@ int board_init(void)
 	/* address of boot parameters */
 	gd->bd->bi_boot_params = PHYS_SDRAM + 0x100;
 
+#ifdef CONFIG_CMD_SATA
+	setup_sata();
+#endif
 	return 0;
 }
 
diff --git a/include/configs/udoo.h b/include/configs/udoo.h
index b9a493c..a1a1750 100644
--- a/include/configs/udoo.h
+++ b/include/configs/udoo.h
@@ -34,6 +34,18 @@
 #define CONFIG_MXC_UART
 #define CONFIG_MXC_UART_BASE		UART2_BASE
 
+/* SATA Configs */
+
+#define CONFIG_CMD_SATA
+#ifdef CONFIG_CMD_SATA
+#define CONFIG_DWC_AHSATA
+#define CONFIG_SYS_SATA_MAX_DEVICE	1
+#define CONFIG_DWC_AHSATA_PORT_ID	0
+#define CONFIG_DWC_AHSATA_BASE_ADDR	SATA_ARB_BASE_ADDR
+#define CONFIG_LBA48
+#define CONFIG_LIBATA
+#endif
+
 /* Network support */
 
 #define CONFIG_CMD_PING
-- 
1.7.10.4