[U-Boot] [RFC 5/5] B4860QDS: Add support of 2 stage NAND boot loader

[Prabhakar Kushwaha]

On 09/20/2013 04:51 AM, Rommel Custodio wrote:
> Dear Prabhakar Kushwaha,
>
> Prabhakar Kushwaha <prabhakar <at> freescale.com> writes:
>>>
> <snipped>
>
> Thank you for the replies.
>
>>> You mention you use the PBL... but probably not a pblimage. The patch
>>> correctly fixes RAMBOOT_PBL as a trigger to generate the pblimage (u-
>>> boot.pbl) but there seems to be no RCW or PBI file defined.
>> B4860 does support PBL based NAND boot.
>> but I have yet to integrate u-boot-spl.bin to generated u-boot-spl.pbl.
>> This is in my TODO list
> This is my understanding (if need be, take it with a grain of salt)
>
> The Makefiles need to be modified so that SPL build will create a pblimage.
> The "mkimage pblimage" needs to be executed only on the SPL binary. Then the
> top-level Makefile proceeds in concatenating the u-boot-spl.bin (now a
> pblimage) and u-boot.bin.
>

yes. This is my next plan.


>>> I have one question, can this scenario be implemented on a P5040? i.e.
>>> simulate that CPC is around 128Kb and load u-boot via SPL? Now all
> corenet
>>> processors seem to only support pblimage booting.
>>>
>> yes. This scenario can be implemented for P5040. Only need to create
>> spl.c file + define constants.
> Seems easy enough :-) though I probably don't have the resources to actually
> implement it.
>
> Just a note. The pblimage booting is not very flexible now. Currently it
> assumes that u-boot.pbl will fit into CPC (configured as SRAM). This is OK
> for most processors (i.e P5040 with 1Mb CPC) but it will not work for others
> (i.e T1040/1042 with only 256Kb CPC). So there is a need to have SPL in this
> case.
>
>

Me along with others  are owner of T1040 platform. This whole exercise 
is done for T1040 & future soc which may have < 512K CPC.
Once base patch of T1040QDS has been accepted(already in review state). 
I will send a patch set to add support of 2 Stage boot loader.

Regards,
Prabhakar