[U-Boot] [PATCH v2 03/16] sunxi: dram: Respect the DDR3 reset timing requirements

[Siarhei Siamashka]

The RESET pin needs to be kept low for at least 200 us according
to the DDR3 spec. So just do it the right way.

This issue did not cause any visible major problems earlier, because
the DRAM RESET pin is usually already low after the board reset. And
the time gap before reaching the sunxi u-boot DRAM initialization
code appeared to be sufficient.

Signed-off-by: Siarhei Siamashka <siarhei.siamashka at gmail.com>
---
Changes for v2:
   - rebase on git://git.denx.de/u-boot-sunxi.git master and resolve
     minor conflicts (udelay in two places instead of one)

 arch/arm/cpu/armv7/sunxi/dram.c | 9 +++++++--
 1 file changed, 7 insertions(+), 2 deletions(-)

diff --git a/arch/arm/cpu/armv7/sunxi/dram.c b/arch/arm/cpu/armv7/sunxi/dram.c
index dc79d1c..a632926 100644
--- a/arch/arm/cpu/armv7/sunxi/dram.c
+++ b/arch/arm/cpu/armv7/sunxi/dram.c
@@ -48,6 +48,11 @@ static void await_completion(u32 *reg, u32 mask)
 	}
 }
 
+/*
+ * This performs the external DRAM reset by driving the RESET pin low and
+ * then high again. According to the DDR3 spec, the RESET pin needs to be
+ * kept low for at least 200 us.
+ */
 static void mctl_ddr3_reset(void)
 {
 	struct sunxi_dram_reg *dram =
@@ -64,13 +69,13 @@ static void mctl_ddr3_reset(void)
 	if ((reg_val & CPU_CFG_CHIP_VER_MASK) !=
 	    CPU_CFG_CHIP_VER(CPU_CFG_CHIP_REV_A)) {
 		setbits_le32(&dram->mcr, DRAM_MCR_RESET);
-		udelay(2);
+		udelay(200);
 		clrbits_le32(&dram->mcr, DRAM_MCR_RESET);
 	} else
 #endif
 	{
 		clrbits_le32(&dram->mcr, DRAM_MCR_RESET);
-		udelay(2);
+		udelay(200);
 		setbits_le32(&dram->mcr, DRAM_MCR_RESET);
 	}
 }
-- 
1.8.3.2