[U-Boot] [PATCH 3/9 v2] powerpc/t1024qds: Add T1024 QDS board support

York Sun yorksun at freescale.com
Fri Dec 5 17:41:42 CET 2014


On 11/24/2014 01:11 AM, Shengzhou Liu wrote:
> T1024QDS is a high-performance computing evaluation, development and
> test platform for T1024 QorIQ Power Architecture processor.
> 
> T1024QDS board Overview
> -----------------------
> - T1024 SoC integrating two 64-bit e5500 cores up to 1.4GHz
> - CoreNet fabric supporting coherent and noncoherent transactions with
>   prioritization and bandwidth allocation
> - 32-/64-bit DDR3L/DDR4 SDRAM memory controller with ECC and interleaving support
> - Accelerator: DPAA components consist of FMan, BMan, QMan, DCE and SEC
> - Ethernet interfaces:
>   - Two 10M/100M/1G RGMII ports on-board
>   - Three 1G/2.5Gbps SGMII ports
>   - Four 1Gbps QSGMII ports
>   - one 10Gbps XFI or 10Base-KR interface
> - SerDes: 4 lanes up to 10.3125GHz Supporting SGMII/QSGMII, XFI, PCIe, SATA and Aurora
> - PCIe: Three PCI Express controllers with five PCIe slots.
> - IFC: 128MB NOR Flash, 2GB NAND Flash, PromJet debug port and Qixis FPGA
> - Video: DIU supports video up to 1280x1024x32 bpp.
>   - Chrontel CH7201 for HDMI connection.
>   - TI DS90C387R for direct LCD connection.
>   - Raw (not encoded) video connector for testing or other encoders.
> - QUICC Engine block
>   - 32-bit RISC controller for flexible support of the communications peripherals
>   - Serial DMA channel for receive and transmit on all serial channels
>   - Two universal communication controllers, supporting TDM, HDLC, and UART
> - Deep Sleep power implementaion (wakeup from GPIO/Timer/Ethernet/USB)
> - eSPI: Three SPI flash devices.
> - SATA: one SATA 2.O.
> - USB: Two USB2.0 ports with internal PHY (one Type-A + one micro Type mini-AB)
> - eSDHC: Support SD, SDHC, SDXC and MMC/eMMC.
> - I2C: Four I2C controllers.
> - UART: Two UART on board.
> 
> Signed-off-by: Shengzhou Liu <Shengzhou.Liu at freescale.com>
> ---
> v2: removed diu.c by using common diu_ch7301.c
> 

Fix ft_board_setup() type
Fix MAINTAINERS for SECURE_BOOT
Fix Kconfig by adding SUPPORT_SPL

Applied to u-boot-mpc85xx, awaiting upstream.

York


More information about the U-Boot mailing list