[U-Boot] [PATCH 3/3] MMC: atmel_mci: enable high speed mode support

[Bo Shen]

If the MCI IP version >= 0x300, it supports hight speed mode
option, this patch enable it.

Signed-off-by: Bo Shen <voice.shen at atmel.com>
---
 drivers/mmc/gen_atmel_mci.c | 7 ++++++-
 1 file changed, 6 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/gen_atmel_mci.c b/drivers/mmc/gen_atmel_mci.c
index 8778a4d..45bcffb 100644
--- a/drivers/mmc/gen_atmel_mci.c
+++ b/drivers/mmc/gen_atmel_mci.c
@@ -110,6 +110,9 @@ static void mci_set_mode(struct mmc *mmc, u32 hz, u32 blklen)
 	if (version >= 0x200)
 		writel(MMCI_BF(BLKLEN, blklen), &mci->blkr);
 
+	if (mmc->card_caps & mmc->cfg->host_caps & MMC_MODE_HS)
+		writel(MMCI_BIT(HSMODE), &mci->cfg);
+
 	initialized = 1;
 }
 
@@ -404,8 +407,10 @@ int atmel_mci_init(void *regs)
 	/* need to be able to pass these in on a board by board basis */
 	cfg->voltages = MMC_VDD_32_33 | MMC_VDD_33_34;
 	version = atmel_mci_get_version(mci);
-	if ((version & 0xf00) >= 0x300)
+	if ((version & 0xf00) >= 0x300) {
 		cfg->host_caps = MMC_MODE_8BIT;
+		cfg->host_caps |= MMC_MODE_HS | MMC_MODE_HS_52MHz;
+	}
 
 	cfg->host_caps |= MMC_MODE_4BIT;
 
-- 
1.8.5.2