[U-Boot] [PATCH 2/2] mvtwsi: Remove unnecessary twsi_baud_rate and twsi_slave_address globals

[Hans de Goede]

These are used only once, so their is no need to have them global.

This also stops mvtwsi from using any bss vars making it easier to use
before dram init (to talk to the pmic to set the dram voltage).

Signed-off-by: Hans de Goede <hdegoede at redhat.com>
---
 drivers/i2c/mvtwsi.c | 23 ++++-------------------
 1 file changed, 4 insertions(+), 19 deletions(-)

diff --git a/drivers/i2c/mvtwsi.c b/drivers/i2c/mvtwsi.c
index b449443..5ba0e03 100644
--- a/drivers/i2c/mvtwsi.c
+++ b/drivers/i2c/mvtwsi.c
@@ -219,24 +219,12 @@ static int twsi_stop(int status)
 	(CONFIG_SYS_TCLK / (10 * (m + 1) * (1 << n)))
 
 /*
- * These are required to be reprogrammed before enabling the controller
- * because a reset loses them.
- * Default values come from the spec, but a twsi_reset will change them.
- * twsi_slave_address left uninitialized lest checkpatch.pl complains.
- */
-
-/* Baudrate generator: m (bits 6..3) = 8, n (bits 2..0) = 4 */
-static u8 twsi_baud_rate = 0x44; /* baudrate at controller reset */
-/* Default slave address is 0 (so is an uninitialized static) */
-static u8 twsi_slave_address;
-
-/*
  * Reset controller.
  * Called at end of i2c_init unsuccessful i2c transactions.
  * Controller reset also resets the baud rate and slave address, so
  * re-establish them.
  */
-static void twsi_reset(void)
+static void twsi_reset(u8 baud_rate, u8 slave_address)
 {
 	/* ensure controller will be enabled by any twsi*() function */
 	twsi_control_flags = MVTWSI_CONTROL_TWSIEN;
@@ -245,9 +233,9 @@ static void twsi_reset(void)
 	/* wait 2 ms -- this is what the Marvell LSP does */
 	udelay(20000);
 	/* set baud rate */
-	writel(twsi_baud_rate, &twsi->baudrate);
+	writel(baud_rate, &twsi->baudrate);
 	/* set slave address even though we don't use it */
-	writel(twsi_slave_address, &twsi->slave_address);
+	writel(slave_address, &twsi->slave_address);
 	writel(0, &twsi->xtnd_slave_addr);
 	/* assert STOP but don't care for the result */
 	(void) twsi_stop(0);
@@ -275,11 +263,8 @@ void i2c_init(int requested_speed, int slaveadd)
 			}
 		}
 	}
-	/* save baud rate and slave for later calls to twsi_reset */
-	twsi_baud_rate = baud;
-	twsi_slave_address = slaveadd;
 	/* reset controller */
-	twsi_reset();
+	twsi_reset(baud, slaveadd);
 }
 
 /*
-- 
1.9.0