[U-Boot] [PATCH 1/2] mvtwsi: Fix clock programming

[Hans de Goede]

The TWSI_FREQUENCY macro was wrong in 2 ways:
1) It was casting the result of the calculations to an u8, while i2c clk
rates are often >= 100Khz which won't fit in a u8, drop the cast.
2) It had an extra factor of 2 in the divider which neither the datasheet nor
the Linux driver have.

The comment for the default value was wrongly saying that m lives in
bits 4-7, while in reality it is in bits 3-6, as can be seen from the correct
shift by 3 used in i2c_init().

While at it remove the unused twsi_actual_speed variable.

Signed-off-by: Hans de Goede <hdegoede at redhat.com>
---
 drivers/i2c/mvtwsi.c | 7 ++-----
 1 file changed, 2 insertions(+), 5 deletions(-)

diff --git a/drivers/i2c/mvtwsi.c b/drivers/i2c/mvtwsi.c
index 90c8387..b449443 100644
--- a/drivers/i2c/mvtwsi.c
+++ b/drivers/i2c/mvtwsi.c
@@ -216,7 +216,7 @@ static int twsi_stop(int status)
  */
 
 #define TWSI_FREQUENCY(m, n) \
-	((u8) (CONFIG_SYS_TCLK / (10 * (m + 1) * 2 * (1 << n))))
+	(CONFIG_SYS_TCLK / (10 * (m + 1) * (1 << n)))
 
 /*
  * These are required to be reprogrammed before enabling the controller
@@ -225,10 +225,8 @@ static int twsi_stop(int status)
  * twsi_slave_address left uninitialized lest checkpatch.pl complains.
  */
 
-/* Baudrate generator: m (bits 7..4) =4, n (bits 3..0) =4 */
+/* Baudrate generator: m (bits 6..3) = 8, n (bits 2..0) = 4 */
 static u8 twsi_baud_rate = 0x44; /* baudrate at controller reset */
-/* Default frequency corresponding to default m=4, n=4 */
-static u8 twsi_actual_speed = TWSI_FREQUENCY(4, 4);
 /* Default slave address is 0 (so is an uninitialized static) */
 static u8 twsi_slave_address;
 
@@ -279,7 +277,6 @@ void i2c_init(int requested_speed, int slaveadd)
 	}
 	/* save baud rate and slave for later calls to twsi_reset */
 	twsi_baud_rate = baud;
-	twsi_actual_speed = highest_speed;
 	twsi_slave_address = slaveadd;
 	/* reset controller */
 	twsi_reset();
-- 
1.9.0