[U-Boot] [PATCH v3 00/11] mx6: SPL NAND support
Tim Harvey
tharvey at gateworks.com
Thu May 22 08:14:22 CEST 2014
On Wed, May 7, 2014 at 10:16 PM, Tim Harvey <tharvey at gateworks.com> wrote:
> This series adds some necessary framework for IMX6 SPL support. The series
> includes support for NAND SPL and has been tested with MMC as well. I have
> tested this on five differing Ventana baseboards with a variety of memory
> (32bit 512MB, 32bit 1024MB, 64bit 1024MB) and CPU configurations (IMX6Q,
> IMX6DL, IMX6S).
>
> This is based on top of Mashahiro Yamada's patch that consolidates
> arch/arm/include/asm/arch-*/spl.h [1]
>
> v3:
> - re-ordered calls in board_init_f
> - replace imx_iomux_v3_setup_multiple_pads_array with additional intelligence
> in imx_iomux_v3_setup_multiple_pads
> - added ifdef's around cpu specific mmdc iocfg functions for code-reduction
> with single-variant board configs
> - added checks for IMX6D
> - added Freescale copyright to boot device support function
> - fixed typo s/IMX6SLD/IMX6SDL
> - encorporated cleanups in mxs_nand_spl.c per feedback
>
> v2:
> - use compatible linker script instead of creating new one
> - remove structure passing data from SPL to u-boot
> - remove dependence on mtdpart, mtdcore, nand_util, nand_ecc, nand_base
> and nand_bbt to bring SPL down in size. This reduced codesize by about 32k
> where now mxs_spl_nand is about 12k total
> - adjust CONFIG_SPL_TEXT_BASE, CONFIG_SPL_STACK and CONFIG_SPL_MAX_SIZE
> to accomodate the IMX6SOLO/DUALLITE which have half the iRAM of the
> IMX6DUAL/IMX6QUAD
> - move boot dev detection into imx-common/spl.c
> - move macros for using pinmux array into iomux-v3.h
> - remove missing/unnecessary include
> - revert mtdparts change
> - use get_ram_size() to detect memory
> - add support for MX6SOLO and MX6DUAL
> - set CS0_END for 4GB so get_ram_size() works
> - updated DDR3 calibration values for ventana boards
> - fixed build issue - only compile spl if doing spl build
> - fixed line length issue in README
> - remove CONFIG_SPL* conditions and conditionally compile instead
> - removed prints for CPU type and DRAM size/width - uboot will print these l
> - removed unused gw_ventana_spl.cfg
> - use common read_eeprom function
> - added MMC support to SPL
> - added Masahiro Yamada's boot mode consolidation patch
> http://patchwork.ozlabs.org/patch/341817 and rebase on top of it
>
> [1] http://patchwork.ozlabs.org/patch/341817/
>
> Tim Harvey (11):
> SPL: NAND: remove CONFIG_SYS_NAND_PAGE_SIZE
> SPL: NAND: add support for mxs nand
> MX6: add common SPL configuration
> MX6: add boot device support for SPL
> IMX: add comments and remove unused struct fields
> MX6: add structs for mmdc and ddr iomux registers
> MX6: add mmdc configuration for MX6Q/MX6DL
> IMX: iomux: add macros to setup iomux for multiple SoC types
> IMX: ventana: split read_eeprom into standalone file
> IMX: ventana: auto-configure for IMX6Q vs IMX6DL
> IMX: ventana: switch to SPL
>
> arch/arm/cpu/armv7/mx6/Makefile | 1 +
> arch/arm/cpu/armv7/mx6/ddr.c | 473 ++++++++++++++++++++++
> arch/arm/imx-common/Makefile | 1 +
> arch/arm/imx-common/cpu.c | 16 +-
> arch/arm/imx-common/iomux-v3.c | 16 +-
> arch/arm/imx-common/spl.c | 81 ++++
> arch/arm/include/asm/arch-mx6/mx6-ddr.h | 231 +++++++++++
> arch/arm/include/asm/imx-common/iomux-v3.h | 25 ++
> board/gateworks/gw_ventana/Makefile | 3 +-
> board/gateworks/gw_ventana/README | 92 +++--
> board/gateworks/gw_ventana/eeprom.c | 89 +++++
> board/gateworks/gw_ventana/gw_ventana.c | 591 +++++++++++++++-------------
> board/gateworks/gw_ventana/gw_ventana.cfg | 15 -
> board/gateworks/gw_ventana/gw_ventana_spl.c | 419 ++++++++++++++++++++
> board/gateworks/gw_ventana/ventana_eeprom.h | 11 +
> boards.cfg | 6 +-
> common/spl/spl_nand.c | 2 +-
> drivers/mtd/nand/Makefile | 1 +
> drivers/mtd/nand/mxs_nand_spl.c | 231 +++++++++++
> include/configs/gw_ventana.h | 11 +
> include/configs/imx6_spl.h | 71 ++++
> 21 files changed, 2047 insertions(+), 339 deletions(-)
> create mode 100644 arch/arm/cpu/armv7/mx6/ddr.c
> create mode 100644 arch/arm/imx-common/spl.c
> create mode 100644 board/gateworks/gw_ventana/eeprom.c
> create mode 100644 board/gateworks/gw_ventana/gw_ventana_spl.c
> create mode 100644 drivers/mtd/nand/mxs_nand_spl.c
> create mode 100644 include/configs/imx6_spl.h
>
> --
> 1.8.3.2
>
Stefano,
Any comments on this series? I realize you've applied the first one
and I'll remove that from any subsequent posts.
Regards,
Tim
More information about the U-Boot
mailing list