[U-Boot] [PATCH 4/5] usb: s3c-otg: Allow custom gusbcfg

Lukasz Majewski l.majewski at samsung.com
Fri Nov 7 10:11:35 CET 2014


Hi Marek,

> On Tuesday, November 04, 2014 at 08:36:57 PM, Pavel Machek wrote:
> > On Tue 2014-11-04 06:07:33, Marek Vasut wrote:
> > > Allow passing in a custom configuration of the gusbcfg register
> > > via platform data.
> > > 
> > > Signed-off-by: Marek Vasut <marex at denx.de>
> > > Cc: Chin Liang See <clsee at altera.com>
> > > Cc: Dinh Nguyen <dinguyen at opensource.altera.com>
> > > Cc: Vince Bridgers <vbridger at altera.com>
> > 
> > Acked-by: Pavel Machek <pavel at denx.de>
> > 
> > >  	debug("Reseting OTG controller\n");
> > > 
> > > -	writel(0<<15		/* PHY Low Power Clock sel*/
> > > +	dflt_gusbcfg =
> > > +		0<<15		/* PHY Low Power Clock sel*/
> > > 
> > >  		|1<<14		/* Non-Periodic TxFIFO
> > > Rewind Enable*/ |0x5<<10	/* Turnaround time*/
> > >  		|0<<9 | 0<<8	/* [0:HNP disable,1:HNP
> > > enable][ 0:SRP disable*/
> > > 
> > > @@ -413,8 +415,12 @@ static void reconfig_usbd(void)
> > > 
> > >  		|0<<6		/* 0: high speed utmi+, 1:
> > > full speed serial*/ |0<<4		/* 0: utmi+, 1:ulpi*/
> > >  		|1<<3		/* phy i/f  0:8bit,
> > > 1:16bit*/
> > > 
> > > -		|0x7<<0,	/* HS/FS Timeout**/
> > > -		&reg->gusbcfg);
> > > +		|0x7<<0;	/* HS/FS Timeout**/
> > > +
> > 
> > "Interesting" comment style. And I'd remove 0x prefixes from
> > constants <8...
> 
> Lukasz, what do you say to just convert those four boards to use the
> gusbcfg platform data afterward ?

+1

It is a very good idea since we are using the same dwc2 IP block for
host (./usb/host/dwc2.c) and device (s3c_hsotg).

> 
> btw. you can find the latest version in u-boot-usb:topic/s3c-otg

I've read comments from Pavel and tested the code up till first build
error :-).

> 
> Best regards,
> Marek Vasut



-- 
Best regards,

Lukasz Majewski

Samsung R&D Institute Poland (SRPOL) | Linux Platform Group


More information about the U-Boot mailing list