[U-Boot] [PATCH v7 4/4] mx6: mx6sabre common: Enable i.MX thermal DM driver

[Ye.Li]

Enable i.MX thermal DM driver to mx6sabre_common.h file. Since the
thermal is used in init_sequence_f, so define the CONFIG_SYS_MALLOC_F_LEN
to support DM driver using in pre relocation phase.

Additional, thermal driver depends on ocotp, make sure to enable
CONFIG_MXC_OCOTP when CONFIG_IMX6_THERMAL is selected.

Signed-off-by: Ye.Li <B37916 at freescale.com>
Signed-off-by: Nitin Garg <nitin.garg at freescale.com>
---
 include/configs/mx6sabre_common.h |    7 ++++++-
 1 files changed, 6 insertions(+), 1 deletions(-)

diff --git a/include/configs/mx6sabre_common.h b/include/configs/mx6sabre_common.h
index 1e10422..9fdd841 100644
--- a/include/configs/mx6sabre_common.h
+++ b/include/configs/mx6sabre_common.h
@@ -25,6 +25,11 @@
 #define CONFIG_INITRD_TAG
 #define CONFIG_REVISION_TAG
 
+#define CONFIG_DM
+#define CONFIG_DM_THERMAL
+#define CONFIG_SYS_MALLOC_F_LEN	(1 << 10)
+#define CONFIG_IMX6_THERMAL
+
 #define CONFIG_SYS_GENERIC_BOARD
 
 /* Size of malloc() pool */
@@ -37,7 +42,7 @@
 #define CONFIG_MXC_UART
 
 #define CONFIG_CMD_FUSE
-#ifdef CONFIG_CMD_FUSE
+#if defined(CONFIG_CMD_FUSE) || defined(CONFIG_IMX6_THERMAL)
 #define CONFIG_MXC_OCOTP
 #endif
 
-- 
1.7.4.1