[U-Boot] [PATCH v7 4/4] mx6: mx6sabre common: Enable i.MX thermal DM driver

Stefano Babic sbabic at denx.de
Fri Nov 21 16:46:07 CET 2014


On 20/11/2014 14:14, Ye.Li wrote:
> Enable i.MX thermal DM driver to mx6sabre_common.h file. Since the
> thermal is used in init_sequence_f, so define the CONFIG_SYS_MALLOC_F_LEN
> to support DM driver using in pre relocation phase.
> 
> Additional, thermal driver depends on ocotp, make sure to enable
> CONFIG_MXC_OCOTP when CONFIG_IMX6_THERMAL is selected.
> 
> Signed-off-by: Ye.Li <B37916 at freescale.com>
> Signed-off-by: Nitin Garg <nitin.garg at freescale.com>
> ---

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================


More information about the U-Boot mailing list