[U-Boot] [PATCH v3 4/8] common: spl: Add interactive DDR debugger support for SPL image

[Huan Wang]

Hello, Albert,

> On Fri, 17 Oct 2014 16:00:30 +0800, Alison Wang <b18965 at freescale.com>
> wrote:
> > To support interactive DDR debugger, cli_simple.o, cli.o,
> > cli_readline.o, command.o, s_record.o, xyzModem.o and cmd_disk.o are
> > all needed for drivers/ddr/fsl/interactive.c.
> >
> > In current common/Makefile, the above .o files are only produced when
> > CONFIG_SPL_BUILD is disabled.
> >
> > For LS102xA, interactive DDR debugger is needed in SD/NAND boot too,
> > and I enabled CONFIG_FSL_DDR_INTERACTIVE. But according to the
> current
> > common/Makfile, all the above .o files are not produced in SPL part
> > because CONFIG_SPL_BUILD is enabled in SPL part, the following error
> > will be shown,
> >
> > drivers/ddr/fsl/built-in.o: In function `fsl_ddr_interactive':
> > /home/wangh/layerscape/u-boot/drivers/ddr/fsl/interactive.c:1871:
> > undefined reference to `cli_readline_into_buffer'
> > /home/wangh/layerscape/u-boot/drivers/ddr/fsl/interactive.c:1873:
> > undefined reference to `cli_simple_parse_line'
> > make[1]: *** [spl/u-boot-spl] Error 1
> > make: *** [spl/u-boot-spl] Error 2
> >
> > So this patch fixed this issue and the above .o files will be
> produced
> > no matter CONFIG_SPL_BUILD is enabled or disabled.
> >
> > Signed-off-by: Alison Wang <alison.wang at freescale.com>
> > ---
> > Change log:
> >  v3: Gave more explaination in the commit.
> >  v2: No change.
> 
> This does not apply cleanly. Could you rebase and resubmit?
[Alison Wang] ok, I will rebase and resubmit the set. Thanks.


Best Regards,
Alison Wang