[U-Boot] avr32 atmel ngw100 support question

[Andreas Bießmann]

Hi Waldemar,

On 14.01.15 00:23, Waldemar Brodkorb wrote:
> Hi Andreas,
> Andreas Bießmann wrote,
> 

> Yes, fileaddr and filesize seemed to be set correctly.
> Uboot> printenv
> baudrate=115200
> ethaddr=00:04:25:1C:5A:AC
> eth1addr=00:04:25:1C:5A:AD
> bootcmd=fsload;bootm
> bootdelay=3
> bootargs=console=ttyS0 root=/dev/nfs ip=dhcp
> bootfile=iod
> stdin=serial
> stdout=serial
> stderr=serial
> ethact=macb1
> filesize=21e20
> fileaddr=10400000
> gatewayip=10.0.0.1
> netmask=255.255.255.0
> ipaddr=10.0.0.11
> serverip=10.0.0.1
> 
> Environment size: 323/65532 bytes
> Uboot> protect off 0x0 +${filesize}
> Un-Protected 10 sectors
> Uboot> erase 0x0 +${filesize}
> Erasing sector   0...Erasing sector   1...Erasing sector
> 2...Erasing sector   3...Erasing sector   4...Erasing sector
> 5...Erasing sector   6...Erasing sector   7...Erasing sector
> 8...Erasing sector   9...
> 
> But unfortunately the device is dead after the erase command.

Damn, this damn old code run completely from NOR. Current u-boot
versions relocate itself to ram after the very first bootstrap. Sorry, I
did not know that these old versions do not relocate itself.

> Where do you live with your JTAG programmer? ;)

In Germany near Nuremberg.

> Is a AVR dragon device usable to reprogram the NGW100?

I think the dragon should work too. I dunno which software to use then
but basically the dragon supports avr32.

> Or what is my cheapest choice now?

You could send me the board. I feel sad breaking your board :( So I'd
pay the postage back (france, right?).

Best regards

Andreas Bießmann