[U-Boot] [PATCH] configs: ls1021atwr: Enable ID EEPROM for SD boot

[Yuan Yao]

I2C1 can work on ls102xa rev2.0 SD boot, so add
ID EEPROM for SD boot.

Signed-off-by: Yuan Yao <yao.yuan at freescale.com>
---
 include/configs/ls1021atwr.h | 2 --
 1 file changed, 2 deletions(-)

diff --git a/include/configs/ls1021atwr.h b/include/configs/ls1021atwr.h
index 7dcb719..59e704e 100644
--- a/include/configs/ls1021atwr.h
+++ b/include/configs/ls1021atwr.h
@@ -278,7 +278,6 @@
 #define CONFIG_SYS_I2C_MXC_I2C3		/* enable I2C bus 3 */
 
 /* EEPROM */
-#ifndef CONFIG_SD_BOOT
 #define CONFIG_ID_EEPROM
 #define CONFIG_SYS_I2C_EEPROM_NXID
 #define CONFIG_SYS_EEPROM_BUS_NUM		1
@@ -286,7 +285,6 @@
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN		1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS	3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS	5
-#endif
 
 /*
  * MMC
-- 
2.1.0.27.g96db324