[U-Boot] [PATCH 3/3] mx7dsabresd: Directly write to register LDOGCTL

Fabio Estevam fabio.estevam at nxp.com
Wed Aug 17 14:46:24 CEST 2016


Register LDOGCTL contains only bit 0 as a valid bit, so there is no need
to do a read-modify-write operation.

Simplify the code by writing directly to this register.

Signed-off-by: Fabio Estevam <fabio.estevam at nxp.com>
---
 board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c | 4 +---
 1 file changed, 1 insertion(+), 3 deletions(-)

diff --git a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
index 66d6795..0175a1b 100644
--- a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
+++ b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
@@ -193,9 +193,7 @@ int power_init_board(void)
 		       reg, rev_id);
 
 		/* disable Low Power Mode during standby mode */
-		pmic_reg_read(pfuze, PFUZE3000_LDOGCTL, &reg);
-		reg |= 0x1;
-		pmic_reg_write(pfuze, PFUZE3000_LDOGCTL, reg);
+		pmic_reg_write(pfuze, PFUZE3000_LDOGCTL, 0x1);
 
 		/* SW1B step ramp up time from 2us to 4us/25mV */
 		reg = 0x40;
-- 
1.9.1



More information about the U-Boot mailing list