[U-Boot] [BUG report] imx6: CACHE Misaligned operation

[Francesco Dolcini]

Dear all,
I am trying current U-Boot master on solidrun microsom i.MX6 and I get a CACHE
error when accessing SD device:

U-Boot SPL 2017.01-rc1-00066-ge5209e3-dirty (Dec 14 2016 - 10:55:06)
Trying to boot from MMC1** First descriptor is NOT a primary desc on 0:1 **


U-Boot 2017.01-rc1-00066-ge5209e3-dirty (Dec 14 2016 - 10:55:06 +0100)

CPU:   Freescale i.MX6Q rev1.5 996 MHz (running at 792 MHz)
CPU:   Extended Commercial temperature grade (-20C to 105C) at 57C
Reset cause: POR
Board: MX6 Cubox-i
DRAM:  2 GiB
MMC:   FSL_SDHC: 0
CACHE: Misaligned operation at range [8ffbaf6c, 8ffbb76c]
CACHE: Misaligned operation at range [8ffbaf6c, 8ffbb76c]
ERROR: v7_outer_cache_inval_range - start address is not aligned - 0x8ffbaf6c
ERROR: v7_outer_cache_inval_range - stop address is not aligned - 0x8ffbb76c
CACHE: Misaligned operation at range [8ffbaf6c, 8ffbb76c]
CACHE: Misaligned operation at range [8ffbaf6c, 8ffbb76c]
ERROR: v7_outer_cache_inval_range - start address is not aligned - 0x8ffbaf6c
ERROR: v7_outer_cache_inval_range - stop address is not aligned - 0x8ffbb76c
** First descriptor is NOT a primary desc on 0:1 **
*** Warning - bad CRC, using default environment

No panel detected: default to HDMI
Display: HDMI (1024x768)
In:    serial
Out:   serial
Err:   serial
Net:   FEC
Error: FEC address not set.

Hit any key to stop autoboot:  0 
=> version

U-Boot 2017.01-rc1-00066-ge5209e3-dirty (Dec 14 2016 - 10:55:06 +0100)
arm-linux-gnueabihf-gcc (Linaro GCC 5.3-2016.05) 5.3.1 20160412
GNU ld (Linaro_Binutils-2016.05) 2.25.0 Linaro 2016_02

U-Boot version is 53e8ca22538c2cec691fe74098684a359302688c with 54e4fcfa3c749a789192e83740a53234182f4ca3 reverted.

I have tried building also with gcc 4.8 without any improvement.
I have not verified if SD is working correctly.
I am using mx6cuboxi_defconfig without any modification.

U-Boot v2016.03 is not showing the problem.

For the sake of completeness the board is a solidrun SOM i4Pro Rev-1.5 on a
HummingBoard2 Edge Rev-1.2

Thanks,
Francesco