[U-Boot] [PATCH 0/6] Add Pine64 support

[Hans de Goede]

Hi,

On 29-03-16 18:08, Alexander Graf wrote:
>
>
> On 29.03.16 17:45, Hans de Goede wrote:
>> Hi,
>>
>> On 03/29/2016 05:29 PM, Alexander Graf wrote:
>>> The Pine64 is a kickstarter backed SBC that runs on the Allwinner A64
>>> SoC.
>>> This SoC can run AArch64 code, so this patch set lifts all arm version
>>> indepenent sunxi code into a mach directory and builds the A64 code
>>> as armv8 (aarch64) code.
>>>
>>> With these patches applied, I can successfully boot my 1GB Pine64+ board
>>> with an openSUSE EFI image.
>>
>> Can you provide some quick instructions on how to test this ? Bonus
>> point for a link to a boot0.bin which I can dd to a sdcard and use
>> with a u-boot.bin build with these patches.
>
> Sure. Grab these all the files in this directory:
>
>    http://csgraf.de/agraf/pine64
>
> Then do
>
>    $ gcc pine64_image.c -o pine64_image
>    $ cat bl31.bin <u-boot-dir>/u-boot.bin > bl31uboot.bin
>    $ ./pine64_image scp.bin bl31uboot.bin u-boot.img
>    $ dd if=boot0.bin of=/dev/mmcblk0 seek=16
>    $ dd if=u-boot.img of=/dev/mmcblk0 seek=80
>
> That should give you a working system. The scp.bin and boot0.bin are
> from the Allwinner binary distribution. ATF (bl31.bin) is built from
> these sources:
>
>
> https://build.opensuse.org/package/show/devel:ARM:Factory:Contrib:Pine64/firmware-pine64

Cool thanks. I'll give this a try this weekend.

Regards,

Hans