[U-Boot] [Patch v6 8/9] armv8: ls1046ardb: Add LS1046ARDB board support

[Prabhakar Kushwaha]

Hi York,

> -----Original Message-----
> From: york sun
> Sent: Thursday, September 08, 2016 10:51 PM
> To: Q.Y. Gong <qianyu.gong at nxp.com>; u-boot at lists.denx.de
> Cc: Prabhakar Kushwaha <prabhakar.kushwaha at nxp.com>; Vincent Hu
> <mingkai.hu at nxp.com>; S.H. Xie <shaohui.xie at nxp.com>; Z.Q. Hou
> <zhiqiang.hou at nxp.com>; Wenbin Song <wenbin.song at nxp.com>; Shengzhou
> Liu <shengzhou.liu at nxp.com>
> Subject: Re: [Patch v6 8/9] armv8: ls1046ardb: Add LS1046ARDB board support
> 
> On 09/07/2016 03:08 AM, Gong Qianyu wrote:
> > From: Mingkai Hu <mingkai.hu at nxp.com>
> >
> > LS1046ARDB Specification:
> > -------------------------
> > Memory subsystem:
> >  * 8GByte DDR4 SDRAM (64bit bus)
> >  * 512 Mbyte NAND flash
> >  * Two 64 Mbyte high-speed SPI flash
> >  * SD connector to interface with the SD memory card
> >  * On-board 4G eMMC
> >
> > Ethernet:
> >  * Two XFI 10G ports
> >  * Two SGMII ports
> >  * Two RGMII ports
> >
> > PCIe:
> >  * PCIe1 (SerDes2 Lane0) to miniPCIe slot
> >  * PCIe2 (SerDes2 Lane1) to x2 PCIe slot
> >  * PCIe3 (SerDes2 Lane2) to x4 PCIe slot
> >
> > SATA:
> >  * SerDes2 Lane3 to SATA port
> >
> > USB 3.0: one super speed USB 3.0 type A port
> > 	 one Micro-AB port
> >
> > UART: supports two UARTs up to 115200 bps for console
> 
> The board specification doesn't belong to commit message. Instead, you
> can add what features have been supported, such as boot source, any
> important commands, special care to prepare the image, etc.
> 

As such there is no guideline about what should be in commit message of a board support.
I request you to guide us with about required things in board support commit message.

It will help future board support patches.

--prabhakar