[U-Boot] [PATCH v3 04/14] MIPS: Enable use of the instruction cache earlier

[Paul Burton]

Enable use of the instruction cache immediately after it has been
initialised. This will only take effect if U-Boot was linked to run from
kseg0 rather than kseg1, but when this is the case the data cache
initialisation code will run cached & thus significantly faster.

Signed-off-by: Paul Burton <paul.burton at imgtec.com>
---

Changes in v3: None
Changes in v2: None

 arch/mips/cpu/start.S      |  8 --------
 arch/mips/lib/cache_init.S | 13 +++++++++++++
 2 files changed, 13 insertions(+), 8 deletions(-)

diff --git a/arch/mips/cpu/start.S b/arch/mips/cpu/start.S
index fc6dd66..827a544 100644
--- a/arch/mips/cpu/start.S
+++ b/arch/mips/cpu/start.S
@@ -12,10 +12,6 @@
 #include <asm/regdef.h>
 #include <asm/mipsregs.h>
 
-#ifndef CONFIG_SYS_MIPS_CACHE_MODE
-#define CONFIG_SYS_MIPS_CACHE_MODE CONF_CM_CACHABLE_NONCOHERENT
-#endif
-
 #ifndef CONFIG_SYS_INIT_SP_ADDR
 #define CONFIG_SYS_INIT_SP_ADDR	(CONFIG_SYS_SDRAM_BASE + \
 				CONFIG_SYS_INIT_SP_OFFSET)
@@ -154,10 +150,6 @@ reset:
 	PTR_LA	t9, mips_cache_reset
 	jalr	t9
 	 nop
-
-	/* ... and enable them */
-	li	t0, CONFIG_SYS_MIPS_CACHE_MODE
-	mtc0	t0, CP0_CONFIG
 #endif
 
 	/* Set up temporary stack */
diff --git a/arch/mips/lib/cache_init.S b/arch/mips/lib/cache_init.S
index bc8ab27..974dfe9 100644
--- a/arch/mips/lib/cache_init.S
+++ b/arch/mips/lib/cache_init.S
@@ -172,6 +172,19 @@ LEAF(mips_cache_reset)
 	cache_loop	t0, t1, t8, INDEX_STORE_TAG_I
 #endif
 
+	/* Enable use of the I-cache by setting Config.K0 */
+	sync
+	mfc0		t0, CP0_CONFIG
+	li		t1, CONFIG_SYS_MIPS_CACHE_MODE
+#if __mips_isa_rev >= 2
+	ins		t0, t1, 0, 3
+#else
+	ori		t0, t0, CONF_CM_CMASK
+	xori		t0, t0, CONF_CM_CMASK
+	or		t0, t0, t1
+#endif
+	mtc0		t0, CP0_CONFIG
+
 	/*
 	 * then initialize D-cache.
 	 */
-- 
2.10.0