[U-Boot] i.MX6QP sd boot issue

[Jagan Teki]

On Wed, Mar 1, 2017 at 6:28 PM, Peng Fan <peng.fan at nxp.com> wrote:
> Hi Jagan,
>
> Did you put J3 to connect 1-2?

What is J3, I couldn't find it. I saw J1 PCIe connector and J2
Headphone Jack. Can you point me J3.

>
> Jumper Boot Selection
> 1 - 2 Do not boot from SPI NOR (default)
> 2 - 3 Boot from SPI NOR
>
>
>> -----Original Message-----
>> From: Jagan Teki [mailto:jagan at openedev.com]
>> Sent: Wednesday, March 01, 2017 8:56 PM
>> To: u-boot at lists.denx.de
>> Cc: Peng Fan <peng.fan at nxp.com>; Stefano Babic <sbabic at denx.de>
>> Subject: Re: [U-Boot] i.MX6QP sd boot issue
>>
>> + ML
>>
>> On Wed, Mar 1, 2017 at 6:23 PM, Jagan Teki <jagan at openedev.com> wrote:
>> > Hi Peng and All,
>> >
>> > I'm trying to boot from SD, on imx6qplus sabre board.
>> >
>> > - SW6: D1-D8 => 0100 0010
>> > - SD card on SD3
>> > - D12 with USB-to-Serial 115200 8N1
>> > - Power supply Output 5V
>> >
>> > Build:
>> > $  make mx6qpsabreauto_defconfig; make $ dd if=u-boot.imx of=/dev/sda
>> > bs=512 seek=2
>> >
>> > When I plug-in power, power supply slot D1, D2 are green and D3 glow
>> > red not able to get the log on uart.
>> >
>> > Any help?
>>
>> thanks!
>> --
>> Jagan Teki
>> Free Software Engineer | www.openedev.com U-Boot, Linux | Upstream
>> Maintainer Hyderabad, India.
>
> Regards,
> Peng.
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/listinfo/u-boot



-- 
Jagan Teki
Free Software Engineer | www.openedev.com
U-Boot, Linux | Upstream Maintainer
Hyderabad, India.