[U-Boot] [PATCH 3/6] wandboard: Avoid calling setup_display() from SPL code

[Fabio Estevam]

From: Fabio Estevam <fabio.estevam at nxp.com>

There is no need call setup_display() from SPL code, so move it to
board_init(), which executes only in U-Boot proper.

Reported-by: Stefano Babic <sbabic at denx.de>
Signed-off-by: Fabio Estevam <fabio.estevam at nxp.com>
---
 board/wandboard/wandboard.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/board/wandboard/wandboard.c b/board/wandboard/wandboard.c
index adfcf48..dde4988 100644
--- a/board/wandboard/wandboard.c
+++ b/board/wandboard/wandboard.c
@@ -376,9 +376,6 @@ int board_eth_init(bd_t *bis)
 int board_early_init_f(void)
 {
 	setup_iomux_uart();
-#if defined(CONFIG_VIDEO_IPUV3)
-	setup_display();
-#endif
 #ifdef CONFIG_SATA
 	/* Only mx6q wandboard has SATA */
 	if (is_cpu_type(MXC_CPU_MX6Q))
@@ -448,6 +445,8 @@ int board_init(void)
 		setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6q_i2c2_pad_info);
 	else
 		setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6dl_i2c2_pad_info);
+
+	setup_display();
 #endif
 
 	return 0;
-- 
2.7.4