[U-Boot] [PATCH] db410c: set clk node to be probed before relocation

[Jorge Ramirez-Ortiz]

On 04/17/2018 02:01 PM, Ramon Fried wrote:
> The clock node is used by the serial driver and it's needed
> before relocation.
> This patch ensures that the msm-serial driver can actually
> use the clock node.
>
> Signed-off-by: Ramon Fried <ramon.fried at linaro.org>
> ---
>   arch/arm/dts/dragonboard410c.dts | 2 ++
>   1 file changed, 2 insertions(+)
>
> diff --git a/arch/arm/dts/dragonboard410c.dts b/arch/arm/dts/dragonboard410c.dts
> index 5ccfe7f8c8..f37ef5d523 100644
> --- a/arch/arm/dts/dragonboard410c.dts
> +++ b/arch/arm/dts/dragonboard410c.dts
> @@ -38,12 +38,14 @@
>   		#size-cells = <0x1>;
>   		ranges = <0x0 0x0 0x0 0xffffffff>;
>   		compatible = "simple-bus";
> +		u-boot,dm-pre-reloc;

I think the intent is to make dm-pre-reloc legacy.
New platforms should be using "u-boot,dm-spl" even if CONFIG_SPL_BUILD 
is not enabled (I believe it should work)

>   
>   		clkc: qcom,gcc at 1800000 {
>   			compatible = "qcom,gcc-apq8016";
>   			reg = <0x1800000 0x80000>;
>   			#address-cells = <0x1>;
>   			#size-cells = <0x0>;
> +			u-boot,dm-pre-reloc;
>   		};
>   
>   		serial at 78b0000 {