[U-Boot] [PATCH v2 0/2] Read default speed and mode values from DT

[Adam Ford]

On Mon, Nov 19, 2018 at 12:01 PM Patrick Delaunay
<patrick.delaunay at st.com> wrote:
>
>
> This serie generalize the commit 96907c0fe50a
> ("dm: spi: Read default speed and mode values from DT")
>
> In case of DT boot, don't read default speed and mode for SPI from
> CONFIG_*, instead read from DT node. This will make sure that boards
> with multiple SPI/QSPI controllers can be probed at different
> bus frequencies and SPI modes.
>
> Today it is only done in the command sf; this patch do the same
> for the other user of the spi_flash_probe(): spl and splash
> to avoid probe issue.
>
>
> Changes in v2:
> - use variables to avoid duplicated code
> - use variables to avoid duplicated code
>
> Patrick Delaunay (2):
>   spl_spi: Read default speed and mode values from DT
>   splash: sf: Read default speed and mode values from DT
>
>  common/spl/spl_spi.c   | 10 ++++++++--
>  common/splash_source.c | 12 ++++++++++--
>  2 files changed, 18 insertions(+), 4 deletions(-)
>

I replied to another thread, but to prevent a hasty decision, I
thought I'd mention that this patch series breaks the da850evm.

U-Boot SPL 2019.01-rc1-00747-g1a3453efed (Dec 10 2018 - 09:07:08 -0600)
Trying to boot from SPI
Warning: SPI speed fallback to 100 kHz

(And repeat the above forever)

I know Jagan just re-did some of the da850 SPI driver and I wonder if
the updated driver just needs mode and speed entries added to platdata
then extracted from platdata when the driver is initialized.

adam
> --
> 2.7.4
>
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> https://lists.denx.de/listinfo/u-boot