[U-Boot] [PATCHv2 00/15] Updates / improvements to bx50v3 support

[Stefano Babic]

Hi Sebastian.

On 10/01/2018 20:31, Sebastian Reichel wrote:
> This series improves the support on the bx50v3 devices (b540v3, b650v3
> and b850v3). Changes outside of the bx50v3 specific areas:
> 
> - Added driver for RX8010SJ RTC.
> - Added functionality to e1000 driver to enable wrting of EEPROM/MAC
>   address.
> 
> Changes since PATCHv1:
>  * Rebased to v2018.01
>  * Fixed compiler warning for qemu amd64 target
> 
> -- Sebastian
> 
> Hannu Lounento (5):
>   net: e1000: add support for writing to EEPROM
>   net: e1000: split e1000_read_mac_addr
>   net: e1000: implement eth_write_hwaddr
>   board: ge: bx50v3: program MAC address to I210
>   board: ge: bx50v3: mount rootfs read-only
> 
> Ian Ray (5):
>   configs: Add network device support for bx50v3 products
>   board: ge: bx50v3: Support FIT and select configuration based on VPD
>   config: ge_bx50v3: read boot script
>   configs: ge_bx50v3: enable bootcount
>   configs: ge_bx50v3: automatic partition selection and video output
>     failure message
> 
> Martyn Welch (3):
>   board: ge: Enable access to i2c bus 1 and 2
>   board: ge: bx50v3: move FEC MAC address programming to driver
>   board: ge: bx50v3: Enable hardware watchdog
> 
> Nandor Han (2):
>   rtc: adding RX8010SJ rtc driver
>   board,ge,bx50v3 - rtc time validation
> 
>  board/ge/bx50v3/bx50v3.c    | 130 ++++++++++-----
>  configs/ge_b450v3_defconfig |   7 +-
>  configs/ge_b650v3_defconfig |   7 +-
>  configs/ge_b850v3_defconfig |   8 +-
>  drivers/net/e1000.c         | 294 +++++++++++++++++++++++++++++++---
>  drivers/net/e1000.h         |   3 +
>  drivers/rtc/Kconfig         |   6 +
>  drivers/rtc/Makefile        |   1 +
>  drivers/rtc/rx8010sj.c      | 378 ++++++++++++++++++++++++++++++++++++++++++++
>  include/configs/ge_bx50v3.h | 190 +++++++++-------------
>  10 files changed, 849 insertions(+), 175 deletions(-)
>  create mode 100644 drivers/rtc/rx8010sj.c
> 

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================