[U-Boot] [PATCH 0/6] Add Bananapi Zero board with OTG supported

[Jun Nie]

Add Bananapi Zero board defconfig and device tree.
OTG device is supported with enabling clock and adding necessary
controller configuration change. USB mass storage is tested as
a test case.

Jun Nie (6):
  sunxi: h3: add usb_otg and OHCI/EHCI for usbc0 on H3
  sunxi: musb: Add fifo config for H3
  sunxi: musb: Enable OTG device clock for H3
  sunxi: musb: Hack dynamic fifo support for H3 OTG
  sunxi: usb_phy: Clear PHYCTL register before writing
  sunxi: Add initial Banana-Pi Zero support

 arch/arm/dts/Makefile                           |   1 +
 arch/arm/dts/sun8i-h2-plus-bananapi-m2-zero.dts | 113 ++++++++++++++++++++++++
 arch/arm/dts/sun8i-h3.dtsi                      |  32 +++++++
 arch/arm/include/asm/arch-sunxi/clock_sun6i.h   |   2 +
 arch/arm/include/asm/arch-sunxi/cpu_sun4i.h     |   4 +
 arch/arm/mach-sunxi/usb_phy.c                   |   8 +-
 configs/bananapi_zero_defconfig                 |  17 ++++
 drivers/usb/musb-new/musb_regs.h                |   3 +-
 drivers/usb/musb-new/sunxi.c                    |  51 +++++++++++
 9 files changed, 229 insertions(+), 2 deletions(-)
 create mode 100644 arch/arm/dts/sun8i-h2-plus-bananapi-m2-zero.dts
 create mode 100644 configs/bananapi_zero_defconfig

-- 
1.9.1