[U-Boot] [PATCH 0/6] Add Bananapi Zero board with OTG supported

[Jagan Teki]

On Fri, Jan 5, 2018 at 1:06 PM, Jun Nie <jun.nie at linaro.org> wrote:
> Add Bananapi Zero board defconfig and device tree.
> OTG device is supported with enabling clock and adding necessary
> controller configuration change. USB mass storage is tested as
> a test case.
>
> Jun Nie (6):
>   sunxi: h3: add usb_otg and OHCI/EHCI for usbc0 on H3
>   sunxi: musb: Add fifo config for H3
>   sunxi: musb: Enable OTG device clock for H3
>   sunxi: musb: Hack dynamic fifo support for H3 OTG
>   sunxi: usb_phy: Clear PHYCTL register before writing

a64 on otg have in ML[1] check if any redundant otherwise it's OK., we
will test these and send next version.

>   sunxi: Add initial Banana-Pi Zero support

similar patch is already in ML [2]

[1] https://patchwork.ozlabs.org/cover/847375/
[2] https://patchwork.ozlabs.org/patch/832937/

-- 
Jagan Teki
Free Software Engineer | www.openedev.com
U-Boot, Linux | Upstream Maintainer
Hyderabad, India.