[U-Boot] [[PATCH v2] 0/8] sunxi: Enable OTG peripheral and host mode on H3

[Jun Nie]

Changes vs V1:
- Add two patches from Chen-Yu to enable host mode
- split USB0 base address change to separate patch
- revise OTG clock enabling patch

Chen-Yu Tsai (2):
  sunxi: Fix USB PHY index for H3/H5/A64
  sunxi: usb_phy: setup USB PHY passby for USB0 on H3/H5/A64

Jun Nie (6):
  sunxi: h3: Sync OTG and HCI nodes from Linux DT
  sunxi: musb: Add fifo config for H3
  sunxi: musb: Hack dynamic fifo support for H3 OTG
  sunxi: musb: Enable OTG device clock for H3
  sunxi: usb_phy: Clear PHYCTL register before writing
  sunxi: H3: set different otg base address per mode

 arch/arm/dts/sun8i-h3.dtsi                    | 32 ++++++++++++++++++++++
 arch/arm/include/asm/arch-sunxi/clock_sun6i.h | 31 +++++++++++-----------
 arch/arm/include/asm/arch-sunxi/cpu_sun4i.h   |  4 +++
 arch/arm/mach-sunxi/usb_phy.c                 | 15 +++++++++--
 drivers/usb/host/ehci-sunxi.c                 |  9 ++++++-
 drivers/usb/host/ohci-sunxi.c                 |  9 ++++++-
 drivers/usb/musb-new/musb_regs.h              |  3 ++-
 drivers/usb/musb-new/sunxi.c                  | 38 ++++++++++++++++++++++++++-
 8 files changed, 119 insertions(+), 22 deletions(-)

-- 
1.9.1