[U-Boot] [PATCH v5 1/5] spi: cadence_spi: Sync DT bindings with Linux

[Jason Rush]

Adopt the Linux DT bindings. This also fixes an issue
with the indaddrtrig register on the Cadence QSPI
device being programmed with the wrong value for the
socfpga arch.

Tested on TI K2G platform:
Tested-by: Vignesh R <vigneshr at ti.com>

Tested on a socfpga-cyclonev board:
Tested-by: Simon Goldschmidt <sgoldschmidt at de.pepperl-fuchs.com>

Signed-off-by: Jason Rush <jarush at gmail.com>
Cc: Marek Vasut <marex at denx.de>
---
Changes for v5:
   - Rebased
Changes for v4:
   - Rebased
Changes for v3:
   - None

 drivers/spi/cadence_qspi.c     | 20 ++++++++++++--------
 drivers/spi/cadence_qspi.h     |  6 +++++-
 drivers/spi/cadence_qspi_apb.c | 15 ++++-----------
 3 files changed, 21 insertions(+), 20 deletions(-)

diff --git a/drivers/spi/cadence_qspi.c b/drivers/spi/cadence_qspi.c
index 9a6e41f330..991a7160bd 100644
--- a/drivers/spi/cadence_qspi.c
+++ b/drivers/spi/cadence_qspi.c
@@ -212,7 +212,7 @@ static int cadence_spi_xfer(struct udevice *dev, unsigned int bitlen,
 
 	/* Set Chip select */
 	cadence_qspi_apb_chipselect(base, spi_chip_select(dev),
-				    CONFIG_CQSPI_DECODER);
+				    plat->is_decoded_cs);
 
 	if ((flags & SPI_XFER_END) || (flags == 0)) {
 		if (priv->cmd_len == 0) {
@@ -296,7 +296,11 @@ static int cadence_spi_ofdata_to_platdata(struct udevice *bus)
 
 	plat->regbase = (void *)data[0];
 	plat->ahbbase = (void *)data[2];
-	plat->sram_size = fdtdec_get_int(blob, node, "sram-size", 128);
+	plat->is_decoded_cs = fdtdec_get_bool(blob, node, "cdns,is-decoded-cs");
+	plat->fifo_depth = fdtdec_get_uint(blob, node, "cdns,fifo-depth", 128);
+	plat->fifo_width = fdtdec_get_uint(blob, node, "cdns,fifo-width", 4);
+	plat->trigger_address = fdtdec_get_uint(blob, node,
+		"cdns,trigger-address", 0);
 
 	/* All other paramters are embedded in the child node */
 	subnode = fdt_first_subnode(blob, node);
@@ -310,12 +314,12 @@ static int cadence_spi_ofdata_to_platdata(struct udevice *bus)
 				       500000);
 
 	/* Read other parameters from DT */
-	plat->page_size = fdtdec_get_int(blob, subnode, "page-size", 256);
-	plat->block_size = fdtdec_get_int(blob, subnode, "block-size", 16);
-	plat->tshsl_ns = fdtdec_get_int(blob, subnode, "tshsl-ns", 200);
-	plat->tsd2d_ns = fdtdec_get_int(blob, subnode, "tsd2d-ns", 255);
-	plat->tchsh_ns = fdtdec_get_int(blob, subnode, "tchsh-ns", 20);
-	plat->tslch_ns = fdtdec_get_int(blob, subnode, "tslch-ns", 20);
+	plat->page_size = fdtdec_get_uint(blob, subnode, "page-size", 256);
+	plat->block_size = fdtdec_get_uint(blob, subnode, "block-size", 16);
+	plat->tshsl_ns = fdtdec_get_uint(blob, subnode, "cdns,tshsl-ns", 200);
+	plat->tsd2d_ns = fdtdec_get_uint(blob, subnode, "cdns,tsd2d-ns", 255);
+	plat->tchsh_ns = fdtdec_get_uint(blob, subnode, "cdns,tchsh-ns", 20);
+	plat->tslch_ns = fdtdec_get_uint(blob, subnode, "cdns,tslch-ns", 20);
 
 	debug("%s: regbase=%p ahbbase=%p max-frequency=%d page-size=%d\n",
 	      __func__, plat->regbase, plat->ahbbase, plat->max_hz,
diff --git a/drivers/spi/cadence_qspi.h b/drivers/spi/cadence_qspi.h
index d1927a4003..83154210bd 100644
--- a/drivers/spi/cadence_qspi.h
+++ b/drivers/spi/cadence_qspi.h
@@ -18,14 +18,18 @@ struct cadence_spi_platdata {
 	unsigned int	max_hz;
 	void		*regbase;
 	void		*ahbbase;
+	bool		is_decoded_cs;
+	u32		fifo_depth;
+	u32		fifo_width;
+	u32		trigger_address;
 
+	// Flash parameters
 	u32		page_size;
 	u32		block_size;
 	u32		tshsl_ns;
 	u32		tsd2d_ns;
 	u32		tchsh_ns;
 	u32		tslch_ns;
-	u32		sram_size;
 };
 
 struct cadence_spi_priv {
diff --git a/drivers/spi/cadence_qspi_apb.c b/drivers/spi/cadence_qspi_apb.c
index e02f2217f4..8309ab8794 100644
--- a/drivers/spi/cadence_qspi_apb.c
+++ b/drivers/spi/cadence_qspi_apb.c
@@ -37,10 +37,6 @@
 #define CQSPI_REG_RETRY				10000
 #define CQSPI_POLL_IDLE_RETRY			3
 
-#define CQSPI_FIFO_WIDTH			4
-
-#define CQSPI_REG_SRAM_THRESHOLD_WORDS		50
-
 /* Transfer mode */
 #define CQSPI_INST_TYPE_SINGLE			0
 #define CQSPI_INST_TYPE_DUAL			1
@@ -51,9 +47,6 @@
 #define CQSPI_DUMMY_CLKS_PER_BYTE		8
 #define CQSPI_DUMMY_BYTES_MAX			4
 
-#define CQSPI_REG_SRAM_FILL_THRESHOLD	\
-	((CQSPI_REG_SRAM_SIZE_WORD / 2) * CQSPI_FIFO_WIDTH)
-
 /****************************************************************************
  * Controller's configuration and status register (offset from QSPI_BASE)
  ****************************************************************************/
@@ -400,7 +393,7 @@ void cadence_qspi_apb_controller_init(struct cadence_spi_platdata *plat)
 	writel(0, plat->regbase + CQSPI_REG_REMAP);
 
 	/* Indirect mode configurations */
-	writel((plat->sram_size/2), plat->regbase + CQSPI_REG_SRAMPARTITION);
+	writel((plat->fifo_depth/2), plat->regbase + CQSPI_REG_SRAMPARTITION);
 
 	/* Disable all interrupts */
 	writel(0, plat->regbase + CQSPI_REG_IRQMASK);
@@ -560,7 +553,7 @@ int cadence_qspi_apb_indirect_read_setup(struct cadence_spi_platdata *plat,
 		addr_bytes = cmdlen - 1;
 
 	/* Setup the indirect trigger address */
-	writel((u32)plat->ahbbase,
+	writel(plat->trigger_address,
 	       plat->regbase + CQSPI_REG_INDIRECTTRIGGER);
 
 	/* Configure the opcode */
@@ -659,7 +652,7 @@ int cadence_qspi_apb_indirect_read_execute(struct cadence_spi_platdata *plat,
 		bytes_to_read = ret;
 
 		while (bytes_to_read != 0) {
-			bytes_to_read *= CQSPI_FIFO_WIDTH;
+			bytes_to_read *= plat->fifo_width;
 			bytes_to_read = bytes_to_read > remaining ?
 					remaining : bytes_to_read;
 			readsl(plat->ahbbase, bb_rxbuf, bytes_to_read >> 2);
@@ -710,7 +703,7 @@ int cadence_qspi_apb_indirect_write_setup(struct cadence_spi_platdata *plat,
 		return -EINVAL;
 	}
 	/* Setup the indirect trigger address */
-	writel((u32)plat->ahbbase,
+	writel(plat->trigger_address,
 	       plat->regbase + CQSPI_REG_INDIRECTTRIGGER);
 
 	/* Configure the opcode */
-- 
2.11.0