[U-Boot] [PATCH v5 0/5] spi: cadence_spi: Adopt Linux DT bindings

[Marek Vasut]

On 01/06/2018 07:17 PM, Jason Rush wrote:
> Adopt the Linux DT bindings. This also fixes an issue
> with the indaddrtrig register on the Cadence QSPI
> device being programmed with the wrong value for the
> socfpga arch.
> 
> Tested on TI K2G platform:
> Tested-by: Vignesh R <vigneshr at ti.com>
> 
> Tested on a socfpga-cyclonev board:
> Tested-by: Simon Goldschmidt <sgoldschmidt at de.pepperl-fuchs.com>
> 
> Signed-off-by: Jason Rush <jarush at gmail.com>
> 
> Jason Rush (5):
>   spi: cadence_spi: Sync DT bindings with Linux
>   dts: cadence_spi: Sync DT bindings with Linux
>   config: cadence_spi: Remove defines read from DT
>   dts: k2g: Clean-up indentation
>   dts: cadence_spi: Update documentation for DT bindings
> 
>  arch/arm/dts/keystone-k2g-evm.dts             | 75 +++++++++++++--------------
>  arch/arm/dts/keystone-k2g.dtsi                |  5 +-
>  arch/arm/dts/socfpga.dtsi                     |  5 +-
>  arch/arm/dts/socfpga_arria10.dtsi             |  4 +-
>  arch/arm/dts/socfpga_arria5_socdk.dts         |  9 ++--
>  arch/arm/dts/socfpga_cyclone5_is1.dts         |  9 ++--
>  arch/arm/dts/socfpga_cyclone5_socdk.dts       |  9 ++--
>  arch/arm/dts/socfpga_cyclone5_sockit.dts      |  9 ++--
>  arch/arm/dts/socfpga_cyclone5_socrates.dts    |  9 ++--
>  arch/arm/dts/socfpga_cyclone5_sr1500.dts      |  9 ++--
>  arch/arm/dts/socfpga_cyclone5_vining_fpga.dts | 18 +++----
>  arch/arm/dts/stv0991.dts                      | 12 +++--
>  doc/device-tree-bindings/spi/spi-cadence.txt  | 13 +++--
>  drivers/spi/cadence_qspi.c                    | 20 ++++---
>  drivers/spi/cadence_qspi.h                    |  6 ++-
>  drivers/spi/cadence_qspi_apb.c                | 15 ++----
>  include/configs/k2g_evm.h                     |  1 -
>  include/configs/socfpga_common.h              |  1 -
>  include/configs/stv0991.h                     |  1 -
>  19 files changed, 113 insertions(+), 117 deletions(-)
> 

Whole series

Acked-by: Marek Vasut <marex at denx.de>

So please apply after 2018.01 is out .
Thanks

-- 
Best regards,
Marek Vasut