[U-Boot] [PATCH 5/8] arm: zynq: Enable DM_ETH and DM_MMC only if subsystem is enabled

[Michal Simek]

Do not enable DM_ETH/MMC if subsystems are not enabled.
This saves memory for memory constrained boards like cse.

Signed-off-by: Michal Simek <michal.simek at xilinx.com>
---

 arch/arm/Kconfig | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
index fdeef4d05d9d..d5fb5fed5c70 100644
--- a/arch/arm/Kconfig
+++ b/arch/arm/Kconfig
@@ -746,10 +746,10 @@ config ARCH_ZYNQ
 	select SPL_BOARD_INIT if SPL
 	select SPL_OF_CONTROL if SPL
 	select DM
-	select DM_ETH
+	select DM_ETH if NET
 	select DM_GPIO
 	select SPL_DM if SPL
-	select DM_MMC
+	select DM_MMC if MMC
 	select DM_SPI
 	select DM_SERIAL
 	select DM_SPI_FLASH
-- 
1.9.1