[U-Boot] [PATCH 1/3] mx6memcal: Fix the UART ports for mx6sabresd/auto boards

[Stefano Babic]

On 03/01/2018 15:55, Fabio Estevam wrote:
> mx6sabresd board uses the following pins for console:
> 
> PAD_CSI0_DAT10__UART1_TX_DATA
> PAD_CSI0_DAT11__UART1_RX_DATA
> 
> ,so put it in the same config option as wandboard.
> 
> mx6sabreauto board uses the following pins for console:
> 
> PAD_KEY_COL0__UART4_TX_DATA
> PAD_KEY_ROW0__UART4_RX_DATA
> 
> So do not mention sabreauto board as part of the UART1_SD3_DAT6_7 option.
> 
> The config option for sabreauto can be added later when needed.
> 
> Signed-off-by: Fabio Estevam <fabio.estevam at nxp.com>
> ---
>  board/freescale/mx6memcal/Kconfig | 12 ++----------
>  1 file changed, 2 insertions(+), 10 deletions(-)
> 
> diff --git a/board/freescale/mx6memcal/Kconfig b/board/freescale/mx6memcal/Kconfig
> index 443804d..9987cba 100644
> --- a/board/freescale/mx6memcal/Kconfig
> +++ b/board/freescale/mx6memcal/Kconfig
> @@ -45,20 +45,12 @@ choice
>  		  NXP SABRELite.
>  
>  	config UART1_CSI0_DAT10_11
> -		bool "UART1 on CSI0_DAT10/11 (Wand)"
> +		bool "UART1 on CSI0_DAT10/11 (Wand, SabreSD)"
>  		depends on SERIAL_CONSOLE_UART1
>  		help
>  		  Choose this configuration if you're using pads
>  		  CSI0_DAT10 and DAT11 for a console on UART1 as
> -		  is done on the i.MX6 Wand board.
> -
> -	config UART1_SD3_DAT6_7
> -		bool "UART1 on SD3_DAT6/7 (SabreSD, SabreAuto)"
> -		depends on SERIAL_CONSOLE_UART1
> -		help
> -		  Choose this configuration if you're using pads
> -		  SD3_DAT6 and DAT7 for a console on UART1 as is
> -		  done on the NXP SABRESD or SABREAUTO designs.
> +		  is done on the i.MX6 Wand board and i.MX6 SabreSD.
>  
>  	config UART1_UART1
>  		bool "UART1 on UART1 (i.MX6SL EVK, WaRP)"
> 
Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================