[U-Boot] [PATCH v3 2/3] Revert "spi: cadence_qspi_apb: Use 32 bit indirect write transaction when possible"
Vignesh R
vigneshr at ti.com
Wed Jan 24 05:14:06 UTC 2018
This reverts commit 57897c13de03ac0136d64641a3eab526c6810387.
Using bounce_buf.c to handle non-DMA alignment problems is bad as
bounce_buf.c does cache manipulations which is not required. Therefore
revert this patch in favour of local bounce buffer solution in the next
patch.
Signed-off-by: Vignesh R <vigneshr at ti.com>
Acked-by: Marek Vasut <marex at denx.de>
Acked-by: Simon Goldschmidt <sgoldschmidt at de.pepperl-fuchs.com>
Reviewed-by: Jason Rush <jarush at gmail.com>
Acked-by: Jason Rush <jarush at gmail.com>
---
drivers/spi/cadence_qspi_apb.c | 26 ++++++--------------------
include/configs/k2g_evm.h | 1 -
include/configs/socfpga_common.h | 1 -
include/configs/stv0991.h | 1 -
4 files changed, 6 insertions(+), 23 deletions(-)
diff --git a/drivers/spi/cadence_qspi_apb.c b/drivers/spi/cadence_qspi_apb.c
index 82e8a9ec4d1c..a57109865d29 100644
--- a/drivers/spi/cadence_qspi_apb.c
+++ b/drivers/spi/cadence_qspi_apb.c
@@ -30,7 +30,6 @@
#include <linux/errno.h>
#include <wait_bit.h>
#include <spi.h>
-#include <bouncebuf.h>
#include "cadence_qspi.h"
#define CQSPI_REG_POLL_US 1 /* 1us */
@@ -722,17 +721,6 @@ int cadence_qspi_apb_indirect_write_execute(struct cadence_spi_platdata *plat,
unsigned int remaining = n_tx;
unsigned int write_bytes;
int ret;
- struct bounce_buffer bb;
- u8 *bb_txbuf;
-
- /*
- * Handle non-4-byte aligned accesses via bounce buffer to
- * avoid data abort.
- */
- ret = bounce_buffer_start(&bb, (void *)txbuf, n_tx, GEN_BB_READ);
- if (ret)
- return ret;
- bb_txbuf = bb.bounce_buffer;
/* Configure the indirect read transfer bytes */
writel(n_tx, plat->regbase + CQSPI_REG_INDIRECTWRBYTES);
@@ -743,11 +731,11 @@ int cadence_qspi_apb_indirect_write_execute(struct cadence_spi_platdata *plat,
while (remaining > 0) {
write_bytes = remaining > page_size ? page_size : remaining;
- writesl(plat->ahbbase, bb_txbuf, write_bytes >> 2);
- if (write_bytes % 4)
- writesb(plat->ahbbase,
- bb_txbuf + rounddown(write_bytes, 4),
- write_bytes % 4);
+ /* Handle non-4-byte aligned access to avoid data abort. */
+ if (((uintptr_t)txbuf % 4) || (write_bytes % 4))
+ writesb(plat->ahbbase, txbuf, write_bytes);
+ else
+ writesl(plat->ahbbase, txbuf, write_bytes >> 2);
ret = wait_for_bit_le32(plat->regbase + CQSPI_REG_SDRAMLEVEL,
CQSPI_REG_SDRAMLEVEL_WR_MASK <<
@@ -757,7 +745,7 @@ int cadence_qspi_apb_indirect_write_execute(struct cadence_spi_platdata *plat,
goto failwr;
}
- bb_txbuf += write_bytes;
+ txbuf += write_bytes;
remaining -= write_bytes;
}
@@ -768,7 +756,6 @@ int cadence_qspi_apb_indirect_write_execute(struct cadence_spi_platdata *plat,
printf("Indirect write completion error (%i)\n", ret);
goto failwr;
}
- bounce_buffer_stop(&bb);
/* Clear indirect completion status */
writel(CQSPI_REG_INDIRECTWR_DONE,
@@ -779,7 +766,6 @@ failwr:
/* Cancel the indirect write */
writel(CQSPI_REG_INDIRECTWR_CANCEL,
plat->regbase + CQSPI_REG_INDIRECTWR);
- bounce_buffer_stop(&bb);
return ret;
}
diff --git a/include/configs/k2g_evm.h b/include/configs/k2g_evm.h
index 535e7124fc80..0a38922a519e 100644
--- a/include/configs/k2g_evm.h
+++ b/include/configs/k2g_evm.h
@@ -93,7 +93,6 @@
#ifndef CONFIG_SPL_BUILD
#define CONFIG_CADENCE_QSPI
#define CONFIG_CQSPI_REF_CLK 384000000
-#define CONFIG_BOUNCE_BUFFER
#endif
#define SPI_MTD_PARTS KEYSTONE_SPI1_MTD_PARTS
diff --git a/include/configs/socfpga_common.h b/include/configs/socfpga_common.h
index ec8bb500504a..f6607b101ec5 100644
--- a/include/configs/socfpga_common.h
+++ b/include/configs/socfpga_common.h
@@ -184,7 +184,6 @@ unsigned int cm_get_l4_sp_clk_hz(void);
unsigned int cm_get_qspi_controller_clk_hz(void);
#define CONFIG_CQSPI_REF_CLK cm_get_qspi_controller_clk_hz()
#endif
-#define CONFIG_BOUNCE_BUFFER
/*
* Designware SPI support
diff --git a/include/configs/stv0991.h b/include/configs/stv0991.h
index fd96979bf897..beb8f1ae9a92 100644
--- a/include/configs/stv0991.h
+++ b/include/configs/stv0991.h
@@ -64,7 +64,6 @@
+ */
#ifdef CONFIG_OF_CONTROL /* QSPI is controlled via DT */
#define CONFIG_CQSPI_REF_CLK ((30/4)/2)*1000*1000
-#define CONFIG_BOUNCE_BUFFER
#endif
--
2.16.0
More information about the U-Boot
mailing list