[U-Boot] [linux-sunxi] [PATCH v2 00/13] Allwinner H6 support (w/ SPL)

[Jagan Teki]

On Thu, Jul 26, 2018 at 12:35 PM, Icenowy Zheng <icenowy at aosc.io> wrote:
>
>
> 于 2018年7月26日 GMT+08:00 下午3:02:50, Jagan Teki <jagan at amarulasolutions.com> 写到:
>>On Sat, Jul 21, 2018 at 1:50 PM, Icenowy Zheng <icenowy at aosc.io> wrote:
>>> This patchset trys to add support for Allwinner H6 SoC to U-Boot.
>>>
>>> Allwinner H6 is a quite new Allwinner SoC, with several parts changed
>>a
>>> lot (memory map, DRAM controller, CCU, so on). The position which SPL
>>> will be loaded (SRAM A1) also changed to 0x20000.
>>>
>>> The Pine H64 board support comes with this patchset, as this is the
>>> first H6 board that I can get (being early bird).
>>>
>>> Icenowy Zheng (13):
>>>   sunxi: change SUNXI_HIGH_SRAM option to SUNXI_SRAM_ADDRESS
>>>   sunxi: add basic memory map definitions of H6 SoC
>>>   sunxi: change RMR64's RVBAR address for H6
>>>   sunxi: change ATF position for H6
>>>   sunxi: add config for SPL at 0x20000 on H6
>>>   sunxi: change GIC address on H6
>>>   sunxi: add clock code for H6
>>>   sunxi: use sun6i-style watchdog for H6
>>>   sunxi: add UART0 setup for H6
>>>   sunxi: add MMC support for H6
>>>   sunxi: add DRAM support to H6
>>>   sunxi: add support for Allwinner H6 SoC
>>>   sunxi: add support for Pine H64 board

Reviewed-by: Jagan Teki <jagan at openedev.com>

>>
>>Observing SPL hang during relocation switch to board_init_r with
>>orangepi board[1], will pine boot? look like both seem similar LPDDR3
>>configs atleast from schematics.
>
> Use v2.1 DRAM patch.

Thanks.

Tested-by: Jagan Teki <jagan at openedev.com>