[U-Boot] [linux-sunxi] [PATCH v2 00/13] Allwinner H6 support (w/ SPL)

[Icenowy Zheng]

在 2018-07-27五的 18:48 +0530，Jagan Teki写道：
> On Thu, Jul 26, 2018 at 12:35 PM, Icenowy Zheng <icenowy at aosc.io>
> wrote:
> > 
> > 
> > 于 2018年7月26日 GMT+08:00 下午3:02:50, Jagan Teki <
> > jagan at amarulasolutions.com> 写到:
> > > On Sat, Jul 21, 2018 at 1:50 PM, Icenowy Zheng <icenowy at aosc.io>
> > > wrote:
> > > > This patchset trys to add support for Allwinner H6 SoC to U-
> > > > Boot.
> > > > 
> > > > Allwinner H6 is a quite new Allwinner SoC, with several parts
> > > > changed
> > > 
> > > a
> > > > lot (memory map, DRAM controller, CCU, so on). The position
> > > > which SPL
> > > > will be loaded (SRAM A1) also changed to 0x20000.
> > > > 
> > > > The Pine H64 board support comes with this patchset, as this is
> > > > the
> > > > first H6 board that I can get (being early bird).
> > > > 
> > > > Icenowy Zheng (13):
> > > >   sunxi: change SUNXI_HIGH_SRAM option to SUNXI_SRAM_ADDRESS
> > > >   sunxi: add basic memory map definitions of H6 SoC
> > > >   sunxi: change RMR64's RVBAR address for H6
> > > >   sunxi: change ATF position for H6
> > > >   sunxi: add config for SPL at 0x20000 on H6
> > > >   sunxi: change GIC address on H6
> > > >   sunxi: add clock code for H6
> > > >   sunxi: use sun6i-style watchdog for H6
> > > >   sunxi: add UART0 setup for H6
> > > >   sunxi: add MMC support for H6
> > > >   sunxi: add DRAM support to H6
> > > >   sunxi: add support for Allwinner H6 SoC
> > > >   sunxi: add support for Pine H64 board
> 
> Reviewed-by: Jagan Teki <jagan at openedev.com>

Do you consider merge it now?

> 
> > > 
> > > Observing SPL hang during relocation switch to board_init_r with
> > > orangepi board[1], will pine boot? look like both seem similar
> > > LPDDR3
> > > configs atleast from schematics.
> > 
> > Use v2.1 DRAM patch.
> 
> Thanks.
> 
> Tested-by: Jagan Teki <jagan at openedev.com>
>