i.MX8MM-EVK Boot failure

[Peng Fan]

> Subject: Re: i.MX8MM-EVK Boot failure
> 
> Hi Peng,
> 
> On Tue, Dec 10, 2019 at 10:48 PM Peng Fan <peng.fan at nxp.com> wrote:
> 
> > What you modified? It boots well with Tom's tree.
> 
> Does imx8mq-evk also boot for you?
> 
> I followed the imx8mq-evk README instructions and it does not boot here.
> 
> Maybe you are using different ATF/DDR firmware versions?
> 
> Does it work if you follow the README steps?

I not download that, just use my local ATF/DDR,
U-Boot SPL 2020.01-rc4-00208-g520f955902 (Dec 11 2019 - 11:22:53 +0800)
PMIC:  PFUZE100 ID=0x10
DDRINFO: start DRAM init
DDRINFO:ddrphy calibration done
DDRINFO: ddrmix config done
Normal Boot
Trying to boot from MMC2
NOTICE:  Configuring TZASC380
NOTICE:  RDC off
NOTICE:  BL31: v2.0(release):rel_imx_4.14.98_2.3.0_rc1-1-g8138ffe5c-dirty
NOTICE:  BL31: Built : 03:17:34, Dec 11 2019
NOTICE:  sip svc init


U-Boot 2020.01-rc4-00208-g520f955902 (Dec 11 2019 - 11:22:53 +0800)

CPU:   Freescale i.MX8MQ rev2.1 at 1000 MHz
Reset cause: POR
Model: NXP i.MX8MQ EVK
DRAM:  3 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
Loading Environment from MMC... unable to select a mode
*** Warning - No block device, using default environment

In:    serial
Out:   serial
Err:   serial
Net:
Warning: ethernet at 30be0000 using MAC address from ROM
eth0: ethernet at 30be0000
Hit any key to stop autoboot:  0

But there is true a mmc env issue here, I am checking.

Thanks,
Peng.

> 
> Thanks