[U-Boot] PMIC initialization

[Jeroen van der Laan]

Hi there,

I'm working on a board that is based on a i.Mx6soloX it has a PFUZE3000 PMIC the u-boot version we're using is 2016-03. The PMIC is by default configured with a voltage for our DRAM that is too low. We've discovered that this is an issue with some boards some of the time. The voltage is just below the bare minimum so I think the board has no big issue most of the time.

I want to adjust the voltage in u-boot in time for the board bring up. I'm afraid that a lot of issues will disappear but our tests will not cover if the initialization is too late. I want to be absolutely certain that it happens on time before the memory initialization.

what is the place to do this?
Should I use an SPL bootloader?
Is power_init_board soon enough, or does code in this place require RAM?
Are there any other options?

Best regards,
Jeroen van der Laan


[ICT zorgt voor mensen]<https://www.zorg-en-ict.nl/default.aspx>


Dit e-mailbericht is uitsluitend bestemd voor de geadresseerde. Als dit bericht niet voor u bestemd is, wordt u vriendelijk verzocht dit aan de afzender te melden.
Van Breda BV staat door de elektronische verzending van dit bericht niet in voor de juiste en volledige overbrenging van de inhoud, noch voor tijdige ontvangst daarvan.
Voor informatie over Van Breda BV raadpleegt u www.vanbreda.nl<http://www.vanbreda.nl>.

This e-mail is intended for the addressee's eyes only. If you are not the intended recipient, you are hereby kindly requested to inform the sender of this.
In view of the electronic nature of this communication, Van Breda BV is neither liable for the proper and complete transmission of the information contained therein nor for any delay in its receipt.
For information about Van Breda BV, please visit www.vanbreda.nl<http://www.vanbreda.nl>.