[U-Boot] [PATCH 3/3] mtd: spi: Kconfig: Select SPI_FLASH if DM_SPI_FLASH

[Vignesh R]

On 09/02/19 5:45 PM, Jagan Teki wrote:
> DM_SPI_FLASH should require spi flash interface code for dm
> version, so select SPI_FLASH core by default if any board
> enabled DM_SPI_FLASH.
> 
> This overcome the explicit enablement of CONFIG_SPI_FLASH on
> respective boards when DM_SPI_FLASH being used.
> > Cc: Vignesh R <vigneshr at ti.com>
> Signed-off-by: Jagan Teki <jagan at amarulasolutions.com>
> ---
>  drivers/mtd/spi/Kconfig | 1 +
>  1 file changed, 1 insertion(+)
> 
> diff --git a/drivers/mtd/spi/Kconfig b/drivers/mtd/spi/Kconfig
> index 605f60c713..43f597ec29 100644
> --- a/drivers/mtd/spi/Kconfig
> +++ b/drivers/mtd/spi/Kconfig
> @@ -3,6 +3,7 @@ menu "SPI Flash Support"
>  config DM_SPI_FLASH
>  	bool "Enable Driver Model for SPI flash"
>  	depends on DM && DM_SPI
> +	select SPI_FLASH

How about imply instead of select since there is no compile time dependency?

>  	help
>  	  Enable driver model for SPI flash. This SPI flash interface
>  	  (spi_flash_probe(), spi_flash_write(), etc.) is then
> 

-- 
Regards
Vignesh