[U-Boot] [PATCH v2] warp7: README: Adjust the binary name after DM conversion

[Joris Offouga]

Le 09/02/2019 à 15:01, Fabio Estevam a écrit :
> After the conversion to DM the U-Boot binary is called u-boot-dtb.imx,
> so fix the README file accordingly.
>
> Signed-off-by: Fabio Estevam <festevam at gmail.com>
> ---
> Changes since v1:
> - Fix all occurrances
>
>   board/warp7/README | 12 ++++++------
>   1 file changed, 6 insertions(+), 6 deletions(-)
>
> diff --git a/board/warp7/README b/board/warp7/README
> index 60339da543..579bb2de38 100644
> --- a/board/warp7/README
> +++ b/board/warp7/README
> @@ -17,7 +17,7 @@ $ make mrproper
>   $ make warp7_config

Hi Fabio

Fix typo warp7_config into warp7_defconig

>   $ make
>   
> -This will generate the U-Boot binary called u-boot.imx.
> +This will generate the U-Boot binary called u-boot-dtb.imx.
>   
>   Put warp7 board in USB download mode:
>   
> @@ -28,11 +28,11 @@ Connect a USB to serial adapter between the host PC and warp7
>   
>   Connect a USB cable between the OTG warp7 port and the host PC
>   
> -Copy u-boot.imx to the imx_usb_loader folder.
> +Copy u-boot-dtb.imx to the imx_usb_loader folder.
>   
> -Load u-boot.imx via USB:
> +Load u-boot-dtb.imx via USB:
>   
> -$ sudo ./imx_usb u-boot.imx
> +$ sudo ./imx_usb u-boot-dtb.imx
>   
>   Then U-Boot should start and its messages will appear in the console program.
>   
> @@ -46,9 +46,9 @@ Use the default environment variables:
>   Run the DFU command:
>   => dfu 0 mmc 0
>   
> -Transfer u-boot.imx that will be flashed into the eMMC:
> +Transfer u-boot-dtb.imx that will be flashed into the eMMC:
>   
> -$ sudo dfu-util -D u-boot.imx -a boot
> +$ sudo dfu-util -D u-boot-dtb.imx -a boot
>   
>   Then on the U-Boot prompt the following message should be seen after a
>   successful upgrade: