[U-Boot] [BUG] booting on the Tinker Board (tinker-rk3288_defconfig) is broken

[Heinrich Schuchardt]

On 2/13/19 11:56 AM, Philipp Tomsich wrote:
> 
> 
>> On 13.02.2019, at 11:52, David Wu <david.wu at rock-chips.com> wrote:
>>
>> Hi philipp,
>>
>> 在 2019/2/13 下午6:47, Philipp Tomsich 写道:
>>>> On 13.02.2019, at 11:33, David Wu <david.wu at rock-chips.com> wrote:
>>>>
>>>>
>>>>
>>>> 在 2019/2/13 下午6:13, Philipp Tomsich 写道:
>>>>>> On 13.02.2019, at 11:10, David Wu <david.wu at rock-chips.com> wrote:
>>>>>>
>>>>>> Hi Philipp,
>>>>>>
>>>>>> 在 2019/2/12 下午9:54, Philipp Tomsich 写道:
>>>>>>>> On 12.02.2019, at 13:38, David Wu <david.wu at rock-chips.com> wrote:
>>>>>>>>
>>>>>>>> Hi Philipp,
>>>>>>>>
>>>>>>>> 在 2019/2/10 上午2:24, Philipp Tomsich 写道:
>>>>>>>>> That said, I have been fighting issues from this patchset when trying to read
>>>>>>>>> from devices on the i2c0 bus on a RK3399—which had me add a “simple”
>>>>>>>>> pinctrl device again, as pulling all the dependencies into the SPL is a pain.
>>>>>>>>
>>>>>>>> I think you can also add the simple ops if necessary. Full pinctrl
>>>>>>>> should only be used at the U-boot stage, or the SPL stage where the TPL is available.
>>>>>>>>
>>>>>>>> For most boards about 3288, there is no need to enable pinctrl at SPL
>>>>>>>> stage, such as Tinker board.
>>>>>>> Could you check whether TPL_MAX_SIZE and SPL_MAX_SIZE are correct for
>>>>>>> the RK3288? If not, please submit a patch.
>>>>>>
>>>>>> It is correct, 32KB.
>>>>> Interesting...
>>>>> I wonder why the build did not fail then, if SPL became too big.
>>>>
>>>> Popmetal is okay, the SPL is too big for Tinker, i didn't test Tinker.
>>> If it is too big for Tinker: does the build fail or silently ignore the error?
>> build is okay, mkimage can get the error, i just build, not to mkimage for Tinker.
> 
> This is more than enough (mkimage is part of the build for me!)
> I was just wondering why Heinrich ran into this problem and didn’t 
> see a build error (even at the mkimage stage).
> 
> 

Hello David, hello Philipp,

what are your ideas to reduce the SPL size to under 0x7800 again?
Or will you move all rk3288 boards to TPL like TARGET_VYASA_RK3288?

Best regards

Heinrich