[U-Boot] [U-Boot, 03/14] imx: ventana: remove setup of I2C3 from SPL

[sbabic at denx.de]

> Do not setup I2C3 in the SPL for Ventana as some devices on that bus
> (aic3x codecs) can hang the bus causing i2c_setup to spin endlessly until
> they are put into reset. Removing the setup of I2C3 from the SPL allows
> the board-specific GPIO to be configured to take care of putting codecs
> in reset prior to U-Boot setting up I2C3.
> Signed-off-by: Tim Harvey <tharvey at gateworks.com>

Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================