[U-Boot] [PATCH v3 06/10] pinctrl: rockchip: Special treatment for RK3288 gpio0 pins' drive strength

Kever Yang kever.yang at rock-chips.com
Tue May 7 03:43:44 UTC 2019



On 04/16/2019 09:56 PM, David Wu wrote:
> RK3288 pmu_gpio0 drive strength setting have no higher 16 writing
> corresponding bits, need to read before write the register.
>
> Signed-off-by: David Wu <david.wu at rock-chips.com>

Reviewed-by: Kever Yang <kever.yang at rock-chips.com>

Thanks,
- Kever
> ---
>
> Change in v3:
> - Add some comment
>
>  drivers/pinctrl/rockchip/pinctrl-rk3288.c | 11 +++++++++--
>  1 file changed, 9 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/pinctrl/rockchip/pinctrl-rk3288.c b/drivers/pinctrl/rockchip/pinctrl-rk3288.c
> index 6ae9f1c76e..d1b9aeb3d9 100644
> --- a/drivers/pinctrl/rockchip/pinctrl-rk3288.c
> +++ b/drivers/pinctrl/rockchip/pinctrl-rk3288.c
> @@ -143,8 +143,15 @@ static int rk3288_set_drive(struct rockchip_pin_bank *bank,
>  		return ret;
>  	}
>  
> -	/* enable the write to the equivalent lower bits */
> -	data = ((1 << ROCKCHIP_DRV_BITS_PER_PIN) - 1) << (bit + 16);
> +	/* bank0 is special, there are no higher 16 bit writing bits. */
> +	if (bank->bank_num == 0) {
> +		regmap_read(regmap, reg, &data);
> +		data &= ~(((1 << ROCKCHIP_DRV_BITS_PER_PIN) - 1) << bit);
> +	} else {
> +		/* enable the write to the equivalent lower bits */
> +		data = ((1 << ROCKCHIP_DRV_BITS_PER_PIN) - 1) << (bit + 16);
> +	}
> +
>  	data |= (ret << bit);
>  	ret = regmap_write(regmap, reg, data);
>  	return ret;





More information about the U-Boot mailing list