[U-Boot] [PATCH v3 01/10] pinctrl: rockchip: Add pull-pin-default param and remove unused param【请注意,邮件由u-boot-bounces at lists.denx.de代发】

Kever Yang kever.yang at rock-chips.com
Thu May 9 01:24:01 UTC 2019



On 05/07/2019 11:42 AM, Kever Yang wrote:
>
> On 04/16/2019 09:50 PM, David Wu wrote:
>> Some Socs use the pull-pin-default config param, need to add it.
>> And input-enable/disable config params are not necessary, remove it.
>>
>> Signed-off-by: David Wu <david.wu at rock-chips.com>
> Reviewed-by: Kever Yang <kever.yang at rock-chips.com>

Applied to u-boot-rockchip, thanks!

>
> Thanks,
> - Kever
>> ---
>>
>> Change in v3:
>> - Add some commit message
>>
>>  drivers/pinctrl/rockchip/pinctrl-rockchip-core.c | 3 +--
>>  1 file changed, 1 insertion(+), 2 deletions(-)
>>
>> diff --git a/drivers/pinctrl/rockchip/pinctrl-rockchip-core.c b/drivers/pinctrl/rockchip/pinctrl-rockchip-core.c
>> index b84b079064..77ac981c40 100644
>> --- a/drivers/pinctrl/rockchip/pinctrl-rockchip-core.c
>> +++ b/drivers/pinctrl/rockchip/pinctrl-rockchip-core.c
>> @@ -509,9 +509,8 @@ static const struct pinconf_param rockchip_conf_params[] = {
>>  	{ "bias-bus-hold", PIN_CONFIG_BIAS_BUS_HOLD, 0 },
>>  	{ "bias-pull-up", PIN_CONFIG_BIAS_PULL_UP, 1 },
>>  	{ "bias-pull-down", PIN_CONFIG_BIAS_PULL_DOWN, 1 },
>> +	{ "bias-pull-pin-default", PIN_CONFIG_BIAS_PULL_PIN_DEFAULT, 1 },
>>  	{ "drive-strength", PIN_CONFIG_DRIVE_STRENGTH, 0 },
>> -	{ "input-enable", PIN_CONFIG_INPUT_ENABLE, 1 },
>> -	{ "input-disable", PIN_CONFIG_INPUT_ENABLE, 0 },
>>  	{ "input-schmitt-disable", PIN_CONFIG_INPUT_SCHMITT_ENABLE, 0 },
>>  	{ "input-schmitt-enable", PIN_CONFIG_INPUT_SCHMITT_ENABLE, 1 },
>>  };
>
>
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> https://lists.denx.de/listinfo/u-boot





More information about the U-Boot mailing list