[U-Boot] Cannot boot mx6qsabred with 2019.07-rc2

[Marek Vasut]

On 5/23/19 8:37 PM, Adam Ford wrote:
> On Thu, May 23, 2019 at 1:35 PM Fabio Estevam <festevam at gmail.com> wrote:
>>
>> Hi Adam,
>>
>> On Thu, May 23, 2019 at 3:28 PM Adam Ford <aford173 at gmail.com> wrote:
>>
>>> I have been following this thread, because I have been working through
>>> attempting to migrate the imx6q_logic board to SPL_OF_CONTROL which
>>> requires SPL_DM.
>>>
>>> To working around the issue you're describing, I played with disabling
>>>  SPL_DM_USB.  With that removed, I can still use nearly all the
>>> benefits of SPL_DM without losing access to imx_usb_loader.
>>> See log:
>>
>> I took a look at the configs/imx6q_logic_defconfig file and it does
>> not use FIT support like we do in mx6sabresd.
>>
>> If I remove FIT support then imx_usb_loader works fine here too.
>>
>> imx6q_logic_defconfig only supports the mx6q variant, whereas sabresd
>> needs to support mx6q/dl/qp variants , so we use FIT image that
>> contains therese 3 dtbs.
>>
>> So the problem with SDP at the moment is when trying to load a FIT image.
> 
> Sorry.  I misunderstood the problem.

Would it rather make sense to just stick with non-DM/DT SPL for iMX6 for
now?

-- 
Best regards,
Marek Vasut