[U-Boot] [PATCH] ARM: meson-gx: Reset GXL/GXM to external PHY when not using internal PHY

Neil Armstrong narmstrong at baylibre.com
Fri May 31 08:19:54 UTC 2019


On 28/05/2019 13:13, Neil Armstrong wrote:
> When using External PHY, reset the mux to use the external PHY in case U-Boot
> was chainloaded from a misconfigured bootloader.
> 
> Fixes: 33e3378091 ("ARM: meson: rework soc arch file to prepare for new SoC")
> Signed-off-by: Neil Armstrong <narmstrong at baylibre.com>
> ---
>  arch/arm/mach-meson/board-gx.c | 17 ++++++++++++-----
>  1 file changed, 12 insertions(+), 5 deletions(-)
> 
> diff --git a/arch/arm/mach-meson/board-gx.c b/arch/arm/mach-meson/board-gx.c
> index e41552db52..2b0614b79b 100644
> --- a/arch/arm/mach-meson/board-gx.c
> +++ b/arch/arm/mach-meson/board-gx.c
> @@ -112,6 +112,11 @@ void meson_eth_init(phy_interface_t mode, unsigned int flags)
>  			     GX_ETH_REG_0_TX_RATIO(4) |
>  			     GX_ETH_REG_0_PHY_CLK_EN |
>  			     GX_ETH_REG_0_CLK_EN);
> +
> +		/* Reset to external PHY */
> +		if(!IS_ENABLED(CONFIG_MESON_GXBB))
> +			writel(0x2009087f, GX_ETH_REG_3);
> +
>  		break;
>  
>  	case PHY_INTERFACE_MODE_RMII:
> @@ -119,11 +124,13 @@ void meson_eth_init(phy_interface_t mode, unsigned int flags)
>  		out_le32(GX_ETH_REG_0, GX_ETH_REG_0_INVERT_RMII_CLK |
>  					 GX_ETH_REG_0_CLK_EN);
>  
> -		/* Use GXL RMII Internal PHY */
> -		if (IS_ENABLED(CONFIG_MESON_GXL) &&
> -		    (flags & MESON_USE_INTERNAL_RMII_PHY)) {
> -			writel(0x10110181, GX_ETH_REG_2);
> -			writel(0xe40908ff, GX_ETH_REG_3);
> +		/* Use GXL RMII Internal PHY (also on GXM) */
> +		if (!IS_ENABLED(CONFIG_MESON_GXBB)) {
> +			if ((flags & MESON_USE_INTERNAL_RMII_PHY)) {
> +				writel(0x10110181, GX_ETH_REG_2);
> +				writel(0xe40908ff, GX_ETH_REG_3);
> +			} else
> +				writel(0x2009087f, GX_ETH_REG_3);
>  		}
>  
>  		break;
> 

Applied to u-boot-amlogic


More information about the U-Boot mailing list