[U-Boot] [PATCH] gpio: at91_gpio: Add bank names
Eugen.Hristev at microchip.com
Eugen.Hristev at microchip.com
Mon Nov 18 08:59:59 UTC 2019
On 15.11.2019 19:35, James Byrne wrote:
> Make the at91_gpio driver set sensible GPIO bank names in the platform
> data. This makes the 'gpio status' command a lot more useful.
>
> Signed-off-by: James Byrne <james.byrne at origamienergy.com>
>
> ---
>
> drivers/gpio/at91_gpio.c | 29 ++++++++++++++++++++++++++---
> 1 file changed, 26 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/gpio/at91_gpio.c b/drivers/gpio/at91_gpio.c
> index 965becf77a..94b2b63a04 100644
> --- a/drivers/gpio/at91_gpio.c
> +++ b/drivers/gpio/at91_gpio.c
> @@ -19,6 +19,28 @@
>
> #define GPIO_PER_BANK 32
>
> +static const char *at91_get_bank_name(uint32_t base_addr)
> +{
> + switch (base_addr) {
> + case ATMEL_BASE_PIOA:
> + return "PIOA";
> + case ATMEL_BASE_PIOB:
> + return "PIOB";
> + case ATMEL_BASE_PIOC:
> + return "PIOC";
> +#if (ATMEL_PIO_PORTS > 3)
> + case ATMEL_BASE_PIOD:
> + return "PIOD";
> +#if (ATMEL_PIO_PORTS > 4)
> + case ATMEL_BASE_PIOE:
> + return "PIOE";
> +#endif
> +#endif
> + }
> +
> + return "";
> +}
> +
> static struct at91_port *at91_pio_get_port(unsigned port)
> {
> switch (port) {
> @@ -582,14 +604,15 @@ static int at91_gpio_probe(struct udevice *dev)
>
> clk_free(&clk);
>
> - uc_priv->bank_name = plat->bank_name;
> - uc_priv->gpio_count = GPIO_PER_BANK;
> -
> #if CONFIG_IS_ENABLED(OF_CONTROL)
> plat->base_addr = (uint32_t)devfdt_get_addr_ptr(dev);
> #endif
> + plat->bank_name = at91_get_bank_name(plat->base_addr);
Hello James,
Here you are rewriting the plat->bank_name... What was the old name that
comes from the platform struct ?
Thanks for the patch,
Eugen
> port->regs = (struct at91_port *)plat->base_addr;
>
> + uc_priv->bank_name = plat->bank_name;
> + uc_priv->gpio_count = GPIO_PER_BANK;
> +
> return 0;
> }
>
> --
> 2.24.0
>
>
More information about the U-Boot
mailing list