[U-Boot] rk3288 (Tinkerboard) not booting【请注意，邮件由u-boot-bounces at lists.denx.de代发】

[Alexander von Gluck IV]

Ok, looking for differences now..

* Older Tinker Board?  (I'm not using the Tinker Board S)
* Same steps?
* Same config?  tinker-rk3288_defconfig?
* Uart 115200?
* Any HDMI Video output?
* GCC version?

September 23, 2019 12:34 AM, "Jonathan Gray" <jsg at jsg.id.au> wrote:

> On Mon, Sep 23, 2019 at 01:17:40AM +0000, Alexander von Gluck IV wrote:
> 
>> Hello!
>> 
>> There is no uart output and no video with u-boot master.
>> The board works as expected booting the Asus Armbian image on an SD.
>> 
>> At this point i'd be happy to get some u-boot uart output :-)
>> 
>> -- Alex
> 
> uart output works here with the latest master
> (780a17e814503f71d1b51d578b32bc9c89933183)
> 
> U-Boot TPL 2019.10-rc3-00401-ge23a6e5c43 (Sep 23 2019 - 15:13:20)
> Trying to boot from BOOTROM
> Returning to boot ROM...
> 
> U-Boot SPL 2019.10-rc3-00401-ge23a6e5c43 (Sep 23 2019 - 15:13:20 +1000)
> Trying to boot from MMC1
> 
> U-Boot 2019.10-rc3-00401-ge23a6e5c43 (Sep 23 2019 - 15:13:20 +1000)
> 
> Model: Tinker-RK3288
> DRAM: 2 GiB
> MMC: dwmmc at ff0c0000: 1
> Loading Environment from MMC... *** Warning - bad CRC, using default environment
> 
> In: serial
> Out: serial
> Err: serial
> Model: Tinker-RK3288
> rockchip_dnl_key_pressed: adc_channel_single_shot fail!
> Net: eth0: ethernet at ff290000
> Hit any key to stop autoboot: 0
> switch to partitions #0, OK
> mmc1 is current device
> Scanning mmc 1:1...
> Found EFI removable media binary efi/boot/bootarm.efi
> libfdt fdt_check_header(): FDT_ERR_BADMAGIC
> Scanning disk dwmmc at ff0c0000.blk...
> Found 3 disks
> BootOrder not defined
> EFI boot manager: Cannot load any image
> 88176 bytes read in 9 ms (9.3 MiB/s)
> libfdt fdt_check_header(): FDT_ERR_BADMAGIC
>>> OpenBSD/armv7 BOOTARM 1.6
> 
> boot>