[PATCH v2 06/10] drivers: spi: Add SPI controller driver for Octeon

[Daniel Schwierzeck]

Am Donnerstag, den 30.07.2020, 13:56 +0200 schrieb Stefan Roese:
> From: Suneel Garapati <sgarapati at marvell.com>
> 
> Adds support for SPI controllers found on Octeon II/III and Octeon TX
> TX2 SoC platforms.
> 
> Signed-off-by: Aaron Williams <awilliams at marvell.com>
> Signed-off-by: Suneel Garapati <sgarapati at marvell.com>
> Signed-off-by: Stefan Roese <sr at denx.de>
> Cc: Daniel Schwierzeck <daniel.schwierzeck at gmail.com>
> Cc: Aaron Williams <awilliams at marvell.com>
> Cc: Chandrakala Chavva <cchavva at marvell.com>
> Cc: Jagan Teki <jagan at amarulasolutions.com>
> 
> ---
> 
> Changes in v3:
> - Removed 2nd ops struct for Octeon TX2 and removed "const" from the
>   octeon_spi_ops declaration. This makes a more elegant switch to the
>   Octeon TX2 functions possible, as suggested by Daniel
> - Remove driver_data struct, as its not needed. The distinction between
>   PCI based on non-PCI based probing can be made via a common Octeon TX
>   & TX2 DT property can be made.
> 
> Changes in v2:
> - Newly added to this series
> - Removed inclusion of "common.h"
> - Added "depends on DM_PCI" to Kconfig
> - Tested on MIPS Octeon and ARM Octeon TX2
> - Fixed issues with Octeon TX2 registration. Now only one driver is
>   registered and the "ops" is overwritten in the Octeon TX2 case.
> - Use dev_get_driver_data() to get the driver data struct
> - Removed "struct pci_device_id" definition and U_BOOT_PCI_DEVICE()
>   as its not needed for the PCI based probing on Octeon TX2
> 
>  drivers/spi/Kconfig      |   8 +
>  drivers/spi/Makefile     |   1 +
>  drivers/spi/octeon_spi.c | 615 +++++++++++++++++++++++++++++++++++++++
>  3 files changed, 624 insertions(+)
>  create mode 100644 drivers/spi/octeon_spi.c
> 
> 

Reviewed-by: Daniel Schwierzeck <daniel.schwierzeck at gmail.com>

-- 
- Daniel